Electronics Forum | Wed Oct 10 12:56:26 EDT 2018 | bobpan
ya.....i forgot about that........ mod code 35 and mod code 36 control lighting on the machine. Full brightness is 255. There are also light setting in the configuration file but i tend to keep people out of it. Thanks, Bob
Electronics Forum | Tue Oct 09 15:15:36 EDT 2018 | jsmith01
Does anyone know of a place to get parts or repair for the Quad MV-100 Stencil printer.
Electronics Forum | Fri Oct 26 19:53:48 EDT 2018 | sarason
Suck it and see, start at a 3V pulse, then a 5V pulse, then a 12V pulse, time is not likely to be that critical but a few milliseconds should do! sarason
Electronics Forum | Thu Jun 13 09:28:40 EDT 2019 | dogsbody
Would you still have the pinout you were sent for the Samsung feeders. Kind Regards Andrew
Electronics Forum | Fri Oct 12 11:16:46 EDT 2018 | tech1
Sounds like one of the Z stops is not functioning or needs to be adjusted.
Electronics Forum | Thu Oct 11 06:09:50 EDT 2018 | mk15
hello, Does anyone know about the error F-MOT-MOVE X/245 Motor drive inhibited. The machine hardware initiation ready and approximately an hour later, you will see an error. Thanks
Electronics Forum | Thu Oct 18 16:09:34 EDT 2018 | emeto
Interesting. What changes in 1 hour? Is there any connection between the error and feeder/magazine change, load reload? Is there any other factor observed in the hour of work that is abnormal?
Electronics Forum | Fri Oct 19 08:35:52 EDT 2018 | stephendo
IIRC There is a friction test? If I remember correctly, what is the result?
Electronics Forum | Tue Oct 23 11:19:46 EDT 2018 | tech1
This wound up being a power supply cutting out after a period of operation.
Electronics Forum | Thu Oct 25 01:13:55 EDT 2018 | mk15
thank you for your advice, the problem was in the elmo source 350V, there was a problem of dropping voltage when the engine accelerated.