Electronics Forum | Wed Jul 31 00:47:32 EDT 2019 | nikyta
There is a lot of Asian manufacturer who can answer your question, I'm sure it won't take long to be heard .... ;)
Electronics Forum | Thu Aug 01 05:16:15 EDT 2019 | ameenullakhan
Hi , I have attached a excel file. Hope it might help you. Excel has SMT defects. Few reflow profiling issues are captured over there. Regards, Ameen
Electronics Forum | Thu Aug 01 09:12:58 EDT 2019 | vchauhan
Ameen, Thank you. For some reason I am unable to download any of the three documents. Please try one more time, if not I will give you my email address. Thanks, Vinod.
Electronics Forum | Tue Jul 30 23:54:54 EDT 2019 | rob1
Is possible to view and edit PR1 files from a DEK 265 Horizon on a PC?
Electronics Forum | Thu Aug 01 04:57:10 EDT 2019 | ameenullakhan
hi Team, observed component skew during reflow process. Inductor location. I have attached the image for the same. Please provide your valuable feedback. Attached are the images for the same. Its SAC305 alloy , R0L1 flux chemistry. Regards, Am
Electronics Forum | Thu Aug 01 11:43:57 EDT 2019 | slthomas
I noticed that your solder mask registration is off some. Does it cover a significant portion of any of the pads for these parts? If so, is it possible that the surface tension of the solder at liquidus is enough to skew the part when the solder i
Electronics Forum | Thu Aug 01 13:15:52 EDT 2019 | davef
if the inductors were your only problem. My mom wouldn't be pleased with the V30200C dual voltage rectifier just below the inductors
Electronics Forum | Thu Aug 01 14:18:35 EDT 2019 | huske
Looks like you have too much solder, looks like is balling out of the side of your pads.
Electronics Forum | Thu Aug 01 23:52:12 EDT 2019 | ameenullakhan
Hi ALL, Thanks for your valuable inputs. Will go through the suggestions and come back. Regards, Ameen
Electronics Forum | Fri Aug 02 09:55:41 EDT 2019 | davef
While I agree there is "too much solder" on this board, I don't think that is the sole explanation of what's going on here. I don't think the pads on the board match up well with the terminations on the components.
