Electronics Forum | Tue May 18 08:55:06 EDT 2021 | compit
I bought similar (KOGANEI) for Topaz-X, only the coil of the electromagnet must be the same (voltage). The mechanical part is unlikely to break down - you need to disassember and clean.
Electronics Forum | Wed May 19 20:31:12 EDT 2021 | compit
joy@joysmt.com or from Elissa (I can check the address tomorrow - a person known on this forum).
Electronics Forum | Thu May 20 13:51:07 EDT 2021 | willkillum
Hi Does anybody know if the Juki NF44 mm feeder is compatible with the JX-200 model pick-n-place? Thanks in advance.
Electronics Forum | Fri May 21 01:26:58 EDT 2021 | sophyluo1985
Hi,SMTRPR, JUKI NF44mm feeder can be used on JX-200 pick and place machine,
Electronics Forum | Tue May 25 01:16:00 EDT 2021 | sophyluo1985
If you have any questions, you can send us an email, we are happy to help you,sales07@feedersupplier.com
Electronics Forum | Fri May 21 15:57:08 EDT 2021 | emeto
The thinner the stencil the bigger the variation in terms of percentage. Most probably it was experimentally established, rather than calculated.
Electronics Forum | Sat May 29 06:07:16 EDT 2021 | rsatmech
Thanks, I do observed more solder paste terms of percentage in 0.06mm stencil than in 0.08mm stencil.
Electronics Forum | Fri May 21 12:27:06 EDT 2021 | processman
Hello Have question regarding ASM sx2 head calibration/mapping. If I purchase and fit 2nd user 12 segment CPP head is full ACT mapping required? Or just standard machine calibration ?
Electronics Forum | Fri May 21 14:15:54 EDT 2021 | oxygensmd
RVI-RVII calibration is not enough? In software (both machine configuration on this machine and in machine software you can change head setup). If you have the same head in this machine, all you need to do, head calibration.
Electronics Forum | Fri May 21 15:00:36 EDT 2021 | sophyluo1985
Hi,Sir, Please send me an email to tell you the difficulties you have encountered, maybe we will provide you with more information. Email: sales07@feedersupplier.com