Electronics Forum | Fri Apr 07 17:44:17 EDT 2006 | bobpan
You can either optimize both boards from the very start to the same table top or you can assign the feeders under configure tabletop to the same spot that they were in when you optimized the first program. Remember that you can optimize many differen
Electronics Forum | Fri Apr 21 23:28:54 EDT 2006 | SD
Sounds like you have a non-IQ system? If you can, get one! It makes life much easier. Costly, though! Anyway, as stated above, your best bet is to assign multiple boards to the same table top. If the two boards are 99% similar, use a full opti
Electronics Forum | Mon Apr 24 07:37:57 EDT 2006 | craig_83
We have the IQ system. The problem that I was having is that when I load one board to the other, I want to avoid the table top changeovers. So I figure if I can make certain tabletops to run certain boards the changeovers would be much less. I though
Electronics Forum | Tue Apr 18 15:36:49 EDT 2006 | George
I do not know what kind of products you assemble but don't forget about the cycle time. You probably could accomplish more and faster with a custom nozzle (solder fountain style)for a specific application than point-to-point soldering as laser. I eva
Electronics Forum | Thu Apr 13 17:34:43 EDT 2006 | gencinas
We have been using this new jig for almost a year now, and I can tell you, there is a big difference in our CP's performance before and after the use of the jig. We run a lot of 0402 and 0603 parts. Our downtime has decreased since the very first day
Electronics Forum | Fri Apr 14 23:31:51 EDT 2006 | Pasofol
Have done some rework on BGAs but what kind of minimal pitches/solder balls you dealing with and what kind of volume of rework you planning to do on it? You can get a fancy one which is almost fully automated with alignment so on, others you need t
Electronics Forum | Thu Apr 13 12:58:49 EDT 2006 | caldon
Hi Brian- All is well on my end. I have not been to SMTNET in a long while but pop in from time to time. Working here at Agilent gives me more of an opportunity to check in. How are things on your end? Where are you working these days? Cal
Electronics Forum | Wed Apr 12 06:40:11 EDT 2006 | aj
All, I continuosly have reliability issues when placing a SOT363 device. I have Fuji CP6 and CP4 placement machines. The part data has been analysed down to the finest detail but it is still hard to maintain any consistency. Anyone else have simi
Electronics Forum | Wed Apr 12 15:43:31 EDT 2006 | ted nguyen
Does any one out there know if CSM84V and CSM84VZ can do 0402 parts ? If so, do they actually make 8mmx2mm feeders for these machines. I've had someone tell me they do, but i can't seem to find those feeders anywhere. thank you
Electronics Forum | Thu Apr 13 11:07:15 EDT 2006 | jdengler
If I follow your description correctly (no fiducial correction occuring between load position and 19000 pulses) I agree that the encoder area is the problem. The encoder may be OK but the mechanical connection from the motor to lead screw may have c
.gif)
