Electronics Forum | Tue Sep 19 18:06:05 EDT 2006 | lheiss
Does anyone know of a source for better documentation for the laser align settings? I managed to get a 1206 ceramic capacitor to measure and was working on a 1206 resistor and couldn't get it to succeed. I retried the cap and it failed again and ag
Electronics Forum | Tue Sep 19 22:55:21 EDT 2006 | darby
Hi Larry, me again. Painting the tip should do diddly because you are using laser. Your cap is probably passing because it's thicker and is just inside the range of the system set-up. Check and calibrate your nozzle alignment height settings. Input t
Electronics Forum | Fri Sep 22 04:48:14 EDT 2006 | greg york
Apply the bare minumum amount of VOC free typically 50% less than alcohol fluxes. By doing this you can keep the same top board temperature as alcohol, its only when people over flux do you need to boost up the preheater to volatise of the water. NEV
Electronics Forum | Wed Sep 20 14:20:44 EDT 2006 | Rafael
Dear all, Does anyone know how can I duplicate feeders in the same carriage of the HSP? The issue is: 2 sequenced feeders (101 and 102, for example) with the same part numbers. I need that, when feeder 101 ends, the machine should pick the componen
Electronics Forum | Thu Sep 21 08:06:15 EDT 2006 | bobpan
I think 365 is ok. You should check and make sure the z-rod's spring is ok. Just make sure it is not sticking. Dont waste your money on the pm. If you want a complete list of things to do.....leave an e-mail address and i can e-mail you a list.
Electronics Forum | Thu Sep 21 14:29:58 EDT 2006 | realchunks
Gotcha, I used to be in charge of a pneumatic gun that clipped and bent the leads. Hand held units that worked rather well. The operators where very good at aiming the clipped lead too! Anyway, you may want to visit Panasonic, they have/had a disp
Electronics Forum | Tue Nov 07 23:53:52 EST 2006 | mike white
Panasonics HD range of glue dispensers are good for this kind of job. I suppose the placement machines you have may also determine the dispenser machine. If you have Panasonic placement machines for example a Panasonic HD machine may fit into the foo
Electronics Forum | Tue Nov 21 14:02:34 EST 2006 | jimmyjames
We have 2 Assembleon Opal X II machines, each with 8 head upgrades placing up to 14k CPH. We have got quote back from Essemtec, Asymtek and Camalot. The thing that is holding us back the most is our realatively small budget of $50k US. Screen prin
Electronics Forum | Wed Sep 20 16:05:09 EDT 2006 | ppminc
Does anyone know if it is legal to not sell parts to a customer without paying a $1,500 registration fee? I can understand if I needed technical support. I am referring to Austin American. We sell refurbished equipment & I needed a few parts & a manu
Electronics Forum | Wed Sep 20 16:11:58 EDT 2006 | flipit
I have run into this problem with used equipment that I purchased. Many times I have been unable to buy parts for used equipment. The manufacturer wants to charge some inspection and upgrade fee prior to supporting a used piece of equipment with se
