Electronics Forum | Thu Mar 28 17:13:11 EDT 2024 | tey422
It's been long time, me memories are fading away. If I remember correctly, you would need small flat surface plate or something to cover up the "linescan" hydra camera, so from the reflections value then it can calculates the actual height "lowest"
Electronics Forum | Thu Mar 28 18:00:31 EDT 2024 | alexv
The tapping noise is what you hear when Hydra taps each tool on the tool bank to make sure the tips are seated well. The error is a Z-motor problem. The gear is at the top of the Hydra and needs grease. Have you cleaned the old grease and applied new
Electronics Forum | Tue Apr 02 17:56:44 EDT 2024 | mistrthou
You'll need the specific Mydata part. It has some specific dots and square printed on it. It should be in a box with other calibration parts, stuff which we do at least every 6 months. I attached an internet picture of the box that contains the diff
Electronics Forum | Tue Apr 02 18:25:00 EDT 2024 | kingkelvin
Yes very good - thank you, I'm getting the specific hydra tool offset jig from PFI Florida for $100 - and MyData has already quoted me all the other parts such as in that box there - so I'll get some of these in and continue my work. Thanks all!
Electronics Forum | Tue Apr 02 19:13:02 EDT 2024 | mistrthou
Nice. BTW, I found a pic online. https://www.flasonsmt.com/Uploads/6528ca4e9c5b7.jpg I'm surprised it doesnt have that stuff underneath the machine behind the large panels. Thats where we kept ours.
Electronics Forum | Wed Apr 03 09:12:11 EDT 2024 | hta1979
You have to enter the setup utility.Power off the machine,connect AT keyboard to the rear port, power on,press f1, load the bios setup defaults, enter the hdd parameters,in the first menu (Standard CMOS setup) (Cylinder,Head,Sector,Wprecomp) save the
Electronics Forum | Wed Apr 03 20:23:44 EDT 2024 | lremme
I tried to clone my cfi-128 flash memory card, but can't get it to boot. I am concerned because I have no backup if the original Flash card stops working. Does anybody have a flash card with Topaz-x VIOS and (MSDOS 6.2) preloaded? I would be looking
Electronics Forum | Wed Apr 03 22:07:13 EDT 2024 | compit
Not every program can clone a CF card. I did it but I need to check with what kind. You can also simply insert a new CF card into the machine, INSTALL DOS from floppy disks (same version) and then COPY the entire disk EXCEPT the system files (msdos.s
Electronics Forum | Thu Apr 04 19:13:51 EDT 2024 | proceng1
My original GECKOs all had labels marking them [X, Y, Z, SP] I believe the fuses holders did also. I used a mirror on a stick and I took a set of plastic handle precision screw drivers and cut the handles in half in order to be able to work the smal
Electronics Forum | Fri Apr 05 01:23:29 EDT 2024 | ddfreeze
thank you so much for the info, wished I would have known previously, however I found the motherboard manual online, and located the Dallas CMOS chip soldered to the board. Found a lot of youtube fixes online. Dremel tool and some soldering, added an