Electronics Forum | Mon Jun 12 10:07:08 EDT 2006 | mkehoe@sipad.net
Can someone look this over and see if this helps?? ****************************************************** I read the e-mail threads and I think the respondents are all mixed up on the units of measure. the print reads: Gold Plate (80 mocroinches m
Electronics Forum | Sun Jun 11 21:40:21 EDT 2006 | Wave Master Larry
Grant, I beleive your problem may lie in the top side heater. Only 60% seems too little. I need to run my Soltec way past 60% to get top side wetting on larger part. You may want to have someone fix that. Perhaps Dr. Bocephus H good time budwies
Electronics Forum | Mon Jun 12 19:33:12 EDT 2006 | grantp
Hi, Thanks, and we are doing that today. After spending the day playing with all the usual things that used to work, we are focusing today on profiling and data to get things right. The only worry I have is did we get a wave that can handle this, a
Electronics Forum | Thu Jun 15 19:39:43 EDT 2006 | Bolos
nice to hear from you..my company is an ems.so need a more flexible reflow.. we have 3 lines and soon to install another line for leadfree ideally..so.. its getting a new one hopefully..a seven zone actually i think might do the job... for the wave i
Electronics Forum | Fri Jun 16 14:54:21 EDT 2006 | jbrower
Howdy Bolo, I see. I currently run a 5 zone 1500 Heller, It's a very nice reflow oven and one of my favorites. Hopefully in July we will be getting in our 1700 from Heller. These reflow ovens (used) can be had for a pretty decent price at least in
Electronics Forum | Mon Jun 12 10:46:37 EDT 2006 | mhanc
I am trying to help a customer with a problem. His Process Tech is out and the operator is trying to load a program via floppy. When trying to load on the Amistar 5630 the following errors occur: Data Type Error (level.4) we continue to load and
Electronics Forum | Mon Jun 12 17:32:17 EDT 2006 | flipit
Hi, A little off subject but I just finished a quick little experiment where I placed 0201 to 1206 and some ceramic resonators at specific distances off the scored edge. The distances from scored edge ranged from 0.025" on up at 0.025" increments.
Electronics Forum | Wed Jun 14 01:24:14 EDT 2006 | AR
Thanks ;) We even did some product development on that one. We took a normal bar of wave soldering alloy, sawed a suitable length off it and drilled a carefully measured hole through the bit of solder. The hole is wide enough so that the blister tap
Electronics Forum | Tue Jun 13 13:34:10 EDT 2006 | jsmith01
Does anyone have a Manual for a Hughes/Palomar Htt-1000 power supply and a VTA-96 weld head? I acquired these machines to do a small job that we need to attach a flex cable to a thermal print head. As far as I can tell this division of Hughes was s
Electronics Forum | Wed Jun 14 12:34:50 EDT 2006 | proy
I have been thinking about and looking at writing a Palm based data collection program (using NSbasic, very similar to visualbasic) to replace our PCB inspection sheets. Has anyone done this? I am thinking that the inspector will use a PDA to recor