Electronics Forum | Wed Mar 26 09:19:20 EDT 2008 | nibirta
hi all...well i`m working in such a lab but we are working internally, and for our customers. But i can give you some prices from other labs. Cross section-one location is around: Solder Joint Integrity Std. sample plastic package $300.00 Shorts /
Electronics Forum | Mon Mar 24 14:19:36 EDT 2008 | burb1999
I have a DEK ELA and here is what happens. I print a board after going through the step and it is a dead on print. Then, with another print it will be off in Auto mode (sometimes up and sometimes down, seems to just be up and down not left to right
Electronics Forum | Wed Mar 26 09:26:12 EDT 2008 | lloyd
I know you said you checked your clamps but another look will do no harm. we had a very similar issue a while back, and it turned out that the plastic shim under the chase clamp magnet was damaged. This caused the chase clamps not to release properly
Electronics Forum | Tue Mar 25 12:08:53 EDT 2008 | ludee_circuits
My factory produces Printed Circuits Boards.Today, my customer says they encounter problem with solder ability issue. Some of the boards have difficulties during SMT solder flow. Could not stick to the pads and the components fell off. Those boards
Electronics Forum | Wed Mar 26 08:39:32 EDT 2008 | gabriella
Hello all, I have a interface card(PC) down on one of our Vitronics ovens model SMR-820A. The PC is very old. The card is mounted on ISA slot. Vitronics don't support these any more. Can anyone advise where I can find one of these cards or if I can
Electronics Forum | Thu Mar 27 16:40:45 EDT 2008 | slthomas
(or just some static-safe foam tape) I need to seal a wire terminal block to a board for conformal coating purposes. Currently we glue it to a shim and glue the shim to the board (yuck), but I want to use die cut gaskets if I can make it cost effec
Electronics Forum | Wed Apr 02 09:56:59 EDT 2008 | patsama_n
Every time to create new AOI program we must manual set at bright lighting level for each component. then this case we think the parameter of AOI setting it not concern for this problem due to the golden board that we use to confirm machine before st
Electronics Forum | Sat Mar 29 15:29:06 EDT 2008 | aw
I am printing a ceramic paste through a 160 mesh screen that should have a theoretical wet print thickness of 53um but the only way I can get the print that thin is to increase down stop and slow the stroke. This is causing problems with the mesh, s
Electronics Forum | Fri Apr 11 09:06:40 EDT 2008 | markhoch
I believe we have the Michigan Occupational Safety and Health Administration to thank for our awesome new glasses. I took some of the advice that I was given on here and bought my own Crew Rubicon Safety Glasses from Safety Glasses USA. So at least I
Electronics Forum | Tue Apr 01 07:45:55 EDT 2008 | aj
Hi, We use the standard pin supports when necessary. Are your boards very thin i.e less than 1.6mm ? or maybe panelised ? Other things to check are Z0 placement height aswell as damaged nozzles,sticky nozzle/nozzle head , poor feeders along with t
