Electronics Forum | Wed Mar 07 20:37:38 EST 2001 | davef
I agree. The bar coded label you use should not be affected by the solder mask of the board. The label should have sharp contrast between the segments of the code to modulate the returned light and allow the reader to discriminate between light and
Electronics Forum | Thu Mar 08 09:38:35 EST 2001 | blnorman
We've been using pre-printed labels on our PCB's for years, with 8 - 10 hours a week down time associated with them. Last October we put a CO2 laser marker on one of our lines. In 6 months we've had a total of 30 minutes down time. We use a 2D b
Electronics Forum | Thu Mar 08 05:49:11 EST 2001 | Dreamsniper
Hi, We are encountering a shortage on our parts and our purchasing said that the parts, which is in PLCC packaging, is hard to order from the local and international market and we can only get them in QFP packaging. Now the problem enters here. Our P
Electronics Forum | Wed Mar 14 11:51:24 EST 2001 | fmonette
Popcorning is the common designation for defects related to the moiture sensitivity of plastic molded components, like PBGAs. The plastic body of these parts will absorb moisture from the ambiant atmosphere on your factory floor. If a critical level
Electronics Forum | Wed Mar 14 18:17:40 EST 2001 | mparker
Some thing to watch out for is the cure spec for the adhesive. Will that match with your solder paste reflow spec? You will have two dissimiliar materials going through endothermic reactions at the same time. You could end up with under cured adhesiv
Electronics Forum | Thu Mar 15 15:36:39 EST 2001 | traviss
Don�t be afraid of the more standard doubles sided mixed process. Even without a chip wave it works, don�t get me wrong it works better with the chip wave, but even without chances are you will be spending more on the additional steps than you would
Electronics Forum | Wed Mar 14 17:52:49 EST 2001 | davef
6 Work Life Test 6.1 Obtain a stencil with 15 to 20 rows of a series of 0.025 by 0.050 inch apertures spaced 0.050, 0.040, 0.025, 0.015, 0.010, 0.010, 0.025, 0.040, 0.050 inches apart. See Appendix 1. Source of supply: Metal Etching Technology.
Electronics Forum | Wed Mar 14 17:11:57 EST 2001 | davef
First, x-ray inspection machines have a wide range of capilities. Resolution is a key measure of a machine's ability to "distinguish" features. People say that some x-ray inspection machines have the ability to position the board being inspected at
Electronics Forum | Fri Mar 16 08:38:40 EST 2001 | ctech
C-Tech is the 8th fastest growing company in New Jersey, yet we are so small and can not afford to buy expensive assembly equipment. Currently in production, we have 8 different through-hole boards and 1 surface nount board. In the past we have had
Electronics Forum | Fri Mar 16 09:18:52 EST 2001 | pteerink
just gotta put in my two cents worth...... theories are great, and I do not disagreee that almost all root causes can be traced back to human error. ( just an aside, but it would be a little hard for me to get ahold of the production guy somewhere
