Electronics Forum | Sat May 28 16:14:04 EDT 2011 | kiss
FOV - Feeder Offline Verification. Kit is generally used with FujiTrax for verification, however it can be used to power up the entire feeder pallet while it sits on the pallet change unit of the M3 or M6.
Electronics Forum | Wed Nov 09 09:18:28 EST 2011 | edmaya33
VIT 5K is the best. zero falls calls and effective for pre reflow process. Programming is very easy ( VI pro, edge, blob etc ) 4cm per fov.
Electronics Forum | Sun Dec 11 22:49:23 EST 2011 | darby
7mm FOV with graduations of 0.05mm. They'll cost around $100 - $150. Fun for measuring other "stuff" as well. Enjoy yourself amigo and you're right, printin' is REAL important.
Electronics Forum | Mon Nov 25 20:57:23 EST 2002 | Kermit
Thanks to everyone who has responded so far. We are going with dedicated tooling for our phone cards but not for our system cards so that takes that out of the equation for the former, will evaluate for the system bds.. Thanks for the info.. Regard
Electronics Forum | Wed Nov 16 12:01:59 EST 2011 | benreben
Hi, for me the best system AOI is SAKI because is not a head with a FOV but is a scaner. this scaner take the image board in a few seconds. This machine have many algorithm for inspect all errors on a board. But the interface is difficult and the pr
Electronics Forum | Fri Oct 06 10:19:21 EDT 2000 | JAX
Head, There are no rules on what is placed by machine. Some things to look at: 1. vision alignment issues a. board size ( FOV ) 2. Machine pick-up a. special nozzle b. off center pick-up (depending on machine this could cause a problem) 3. Re
Electronics Forum | Thu Apr 22 01:47:28 EDT 1999 | Larry Johnson
Recently, we have been having problems with PLCC's passing vision on our IP's If the part is set up to be placed on Head 2, it will not always pass vision. However, if we move it over to Head 1, it will pass and place just fine. Now, I do realize
Electronics Forum | Wed Apr 28 00:58:22 EDT 1999 | Will B. Caught
| Recently, we have been having problems with PLCC's passing vision on our IP's If the part is set up to be placed on Head 2, it will not always pass vision. However, if we move it over to Head 1, it will pass and place just fine. Now, I do realiz
Electronics Forum | Mon May 31 11:08:28 EDT 2010 | padawanlinuxero
Hello I am having problems with the hydra camera, I start getting an error message saying that the camera couldnt look at the fiducials on the hydra, I went to the camera in service and turn it on to see the problem but I found out that the real pr
Electronics Forum | Tue Aug 23 22:09:50 EDT 2005 | Ken
You can put a 15, 32, 45, 54 mm lens on a Topaz. However, the 54mm has no published specs. Standard config would use the 45fov single cam. Remember the larger the fov the lower the resolution. Oh and for you guys out there who like the parts per
