Electronics Forum | Fri Jan 15 11:40:37 EST 1999 | Bob Willis
| | I am experiencing a problem with a surface mount coax connector that over time pulls loose from the PWB. The connector has 4 small gold plated leads and we are soldering it to a flash gold board. A cable plugs into the connector and puts some c
Electronics Forum | Sat Jan 16 09:03:28 EST 1999 | Earl Moon
| | | | For the engineers who enjoyed the last two quizs I put on my web page here are two more. One on printed board manufacture and one on rework and repair of surface mount boards. Its a bit of fun but I feel that on line training is coming and is
Electronics Forum | Sat Jan 16 13:30:20 EST 1999 | marc p
| | | | | For the engineers who enjoyed the last two quizs I put on my web page here are two more. One on printed board manufacture and one on rework and repair of surface mount boards. Its a bit of fun but I feel that on line training is coming and
Electronics Forum | Tue Jan 12 15:11:20 EST 1999 | Earl Moon
| | I have an Electrovert UPK 660c fitted with IR preheats top and bottom. We assemble a large range of multilayer backplanes and I was wondering if there are any advantages in changing to convection preheats.Has anybody got any views on the subject.
Electronics Forum | Tue Jan 12 09:29:37 EST 1999 | Dave F
| | | We are currently fighting a dross battle on our non-inerted waves. We are currently using a bar solder that barely meets QQS-571 for Alloy/Impurity. | | | | | | Is anybody using HI FLO in a non inerted wave? Do you see a measureable decrease
Electronics Forum | Sat Nov 14 08:05:54 EST 1998 | Earl Moon
| | | | I believe that gold fingers on my circuit boards are being | | | | contaminated and need to clean them with some chemical | | | | solution. Any recommendations. | | | | | | | Chuck: What is the type and source of your contamination? Dave
Electronics Forum | Mon Nov 02 17:45:46 EST 1998 | ChrisK
In my experience, solder balls are normally caused by only a few things. In order of likelyhood: 1) Water based fluxes (VOC-Free)not having the water carrier completely dried from the board before going into the solder. I.E, too fast conveyor spee
Electronics Forum | Sat Oct 24 23:30:59 EDT 1998 | Pete Sorenson
| I know that this not surface mount, but many of us have to perform multipule duties. Can anyone give me some information on this I am having problems getting relibility | getingthe heat seal ribbon to make consistant electrical contact. | Any help
Electronics Forum | Fri Oct 02 16:49:33 EDT 1998 | Dave F
Benji: I tend to agree with you that assemblers shouldn't wear make-up. I'm unsure what first level assemblers are tho. I've been down that finger cot/glove route ... 1 If someone is going to smear facial or cosmetic oil on a board, they can do
Electronics Forum | Tue Sep 15 19:54:13 EDT 1998 | Wayne Bracy
| Dear Dynapace and those who responded: | Sorry we were not quick enough to delete this ad. However, this gives us a chance to discuss with both users and vendors on ways to facilatate the desemination of product informtion other than via the Forum
