Electronics Forum: front cover not closed (Page 1 of 1)

DEK 265GSX HOOD OPEN ERROR

Electronics Forum | Mon Sep 20 13:55:37 EDT 2010 | jamyboy

Check to make sure that the front and back of the DEK265GSX covers are closed. I have seen issues where the back cover trips its interlock and people go other places to look for the problem.....hope this helps

DEK 288 machine...

Electronics Forum | Thu Sep 20 09:12:28 EDT 2001 | jschake

If you were successful in running the machine in dry cycle mode, then I would expect with new squeegees that the prints would be acceptable. To give you more tangible data on what you may expect from the actual print results, maybe you could run the

Re: Solutions For Low Volume BGA/SMT Rework

Electronics Forum | Thu Feb 19 13:52:58 EST 1998 | mike c

| We are in need of a low cost system for the rework of | various SMT devices. Ideally the machine should support BGA, | SQFP, and large PLCCs. | Is it a dream to ask for SMT tweezers, a regular iron, | and a convection pencil as well? Want a machin

My Wave Is Getting Fixed...

Electronics Forum | Wed Mar 10 19:40:38 EST 1999 | Steve Gregory

Hey Ya'll, My wave solder is getting fixed (...and the crowd goes wild!). Soltec flew in a gentleman named Jorge (not george, it's hor-hay) and he's taking care of me now. Turns out that the problem had to do with the sprocket bearings down at the e

Re: My Wave Is Getting Fixed...

Electronics Forum | Wed Mar 10 22:14:08 EST 1999 | Dean

| Hey Ya'll, | | My wave solder is getting fixed (...and the crowd goes wild!). Soltec flew in a gentleman named Jorge (not george, it's hor-hay) and he's taking care of me now. Turns out that the problem had to do with the sprocket bearings down at

Re: Wave Solder Profiling Basics

Electronics Forum | Fri Jun 25 16:54:25 EDT 1999 | C.K.

| | | Dear John/Earl | | | | | | Thanks for your clarifications. To me also the problem does not seem to be linked with the PCB. The Pre heater temp. is set at | | | 450 degree C. We are using Alpha Aq. cleanable flux. Can you elaborate on the

Cleanroom Basics

Electronics Forum | Fri Jun 24 08:47:14 EDT 2005 | grantp

Hi, There are many aspects to consider. 1. Firstly the room needs to be designed so it's sealed, so linoleum floors than curve where the wall meets the floor, so dirt does not get trapped in the corners, and mops get all dirt and pick it up. Floor

  1  

front cover not closed searches for Companies, Equipment, Machines, Suppliers & Information

Selective soldering solutions with Jade soldering machine

High Precision Fluid Dispensers
Selective Soldering Nozzles

High Throughput Reflow Oven
Software for SMT

World's Best Reflow Oven Customizable for Unique Applications
Electronics Equipment Consignment

High Resolution Fast Speed Industrial Cameras.
Fully Automatic BGA Rework Station

"Heller Korea"