Electronics Forum | Wed Jul 20 22:46:41 EDT 2005 | nozzles
we can supply nozzle for varies machine brand,such as fuji,sanyo and so on. welcome to inquiry that!thanks vera http://www.hkenterprise.com/szcomfaje tel:86-755-28091605 ext.805 eskimy1001@gmail.com
Electronics Forum | Wed Oct 10 09:42:02 EDT 2007 | fredc
Hello Sr.Tech, There have been two types of nozzles made by Fuji for 0201's one was a 1mm tapered to .4mm and the other has a straight .4mm tube. Has one superceded the other and if you have used both types, did one work better than the other? Asking
Electronics Forum | Thu Jan 26 09:13:22 EST 2006 | dougs
i didn't see anything about setting shaft height there, only a procedure for measuring nozzle length. just out of interest, whats the cost difference between a re-tipped nozzle and a new one from fuji? And how much is one of those shaft jigs?
Electronics Forum | Tue Jun 30 06:41:40 EDT 1998 | Wayne Bracy
| Yes there is. There is a company in Texas called: | WP Sales Inc. | 2317-D Roosevelt Drive | Arlington, Texas 76016 | Phone (817) 459-0181 FAX (817) 459-0182 | WEB Page: www.wpsales.com | They sell nozzles for Fuji, KME, TDK, and Panasonic.
Electronics Forum | Mon Jul 12 13:02:38 EDT 2004 | jasont
anybody doing bga placement w/Fuji IP2? what is required if it is possible (camera, nozzles, s/w, etc.), thanks
Electronics Forum | Tue Feb 15 10:38:30 EST 2005 | Dougs
I've seen this before. I had a CP6 doing this for a while, replaced the nozzle springs with ones wound the opposite way from the fuji ones. replaced the springs with these and never had the problem again. you can get them from Ritchie precision eng
Electronics Forum | Wed Sep 16 16:03:36 EDT 1998 | Ben Salisbury
| | | Has anyone used Fuji's rubber tip nozzles for the IP3? Are they O-ring type or suction cup? I'm having trouble picking up Ompacs due to the top of the part not consistently being flat. Any actual experience with these $1100 nozzles would be a
Electronics Forum | Tue Jan 30 10:43:18 EST 2007 | darburch
Before you do anything to the windmills check the heights in your PD's and if you are using board supports be certain that they are set correctly. The CP 65 has approx 1.8mm of travel before the pin will get stuck, as the nozzle should only deflect .
Electronics Forum | Tue Jan 30 12:21:49 EST 2007 | cyber_wolf
Rob, I have talked about this on the forums before. I have since then gained much more experience on this issue. Some things to look at : 1. The X/Y/Z table must be indicated flat. (See the Fuji manual for specs.) 2. Your Z-origin must be correct.
Electronics Forum | Tue Mar 08 10:58:13 EST 2011 | aj
Hi all, This error appeared this morning and prevents me from opening any of the jobs. Everything was working fine yesterday!! Any advise as to how to deal with this? Thanks, Alan...
