Electronics Forum: fuji and robot (Page 1 of 23)

Soldering robot and solder balls

Electronics Forum | Thu Jul 06 03:43:22 EDT 2017 | jamesbarnhart

Electronic devices required higher speed, I/O capability, and density to meet standard requirements. Automated robotic soldering solutions that meet the demands of applications are too challenging for hand soldering. Manual soldering, even with the m

Soldering robot and solder balls

Electronics Forum | Wed Jun 21 11:30:27 EDT 2017 | ranap121212

but we do not have laminate preheating on robots. There is no flux separate application, the flux is in the soldering wire

Soldering robot and solder balls

Electronics Forum | Wed Jun 21 19:01:48 EDT 2017 | mac5

Try baking the boards; you may have a moisture problem.

Soldering robot and solder balls

Electronics Forum | Thu Jun 22 09:50:48 EDT 2017 | capse

Are you using nitrogen in your soldering process?

Soldering robot and solder balls

Electronics Forum | Sat Jun 24 07:49:58 EDT 2017 | ranap121212

@Capse, No but the machine has such a construction, I can not this change

Soldering robot and solder balls

Electronics Forum | Tue Jun 20 15:08:30 EDT 2017 | ranap121212

Hello I have the problem with selective soldering on the robot. Thin balls appear on the laminate. The tin sometimes shoots...? and then the balls are a few millimeters from the soldering point. I tried up or down with temperature, but it did not wor

Soldering robot and solder balls

Electronics Forum | Mon Jun 26 08:57:17 EDT 2017 | capse

If N2 is not an option, the cut wire feeder or drilled wire are your best bet for now. You need to optimize wire feed rate as well. The solder joint on the robot takes about the same time to form as in manual soldering. If you need to speed the solde

Soldering robot and solder balls

Electronics Forum | Wed Jun 21 09:12:42 EDT 2017 | emeto

I would start with checking the flux amount and trace and the thermal profile(preheating is important) for this assembly. Then I would consider changing to another flux and run it again.

Soldering robot and solder balls

Electronics Forum | Sat Jun 24 07:48:05 EDT 2017 | ranap121212

Thanks from your answer. A few days ago the supplier told me about these rolls. Now I am waiting for them and I will make tests. Maybe I will also try to reduce the ejection speed but this will lengthen the process

Soldering robot and solder balls

Electronics Forum | Thu Jun 22 15:05:55 EDT 2017 | solderingpro

There are several different technologies in the industry today to assist in the out-gassing of flux cores. On automated soldering systems, there are two main types of perforating solder feeders: - Hole Drilling - "V" Scoring By perforating the so

  1 2 3 4 5 6 7 8 9 10 Next

fuji and robot searches for Companies, Equipment, Machines, Suppliers & Information