Electronics Forum: fuji cp7/xp142 paper feeder (Page 1 of 1)

SMT reels using paper for caps and have problems with feeder jam

Electronics Forum | Wed Oct 26 11:02:17 EDT 2005 | Rob

I wouldn't say we've escaped either - Fuji blade wear is heavily up at the moment.

SMT reels using paper for caps and have problems with feeder jam

Electronics Forum | Wed Oct 26 10:21:28 EDT 2005 | russ

We are also experiencing problems with this thick stiff paper tape. Our problem is the strength of the spring that supports the tape at its pick position. After a while it just pushes it down because the tape exit wants to bend the tape too sharply

we in urgent want to buy FUJI CP6-4000/CP6-5000;CP643E

Electronics Forum | Wed Jun 04 22:52:32 EDT 2003 | hwatali

Now we are in urgent to buy 1.FUJI CP6-4000 or CP6-5000 for 3 sets;2.FUJI CP643E for 2 sets;3.CP6 8��2 and CP6 8��4 paper feeder. If you can supply these to me,pls contact me asap.

To lubricate feeders or not to lubricate feeders?

Electronics Forum | Sun Feb 05 13:41:47 EST 2006 | bvdb

We recently purchased an old Fuji IP-I placement machine and have been testing 8x4 feeders for 0805 parts, etc. I have opened some of the non-working feeders to replace broken pieces and have noticed that some of the feeders are completely clean ins

Cover tape not always pulling back on Fuji IP-1

Electronics Forum | Fri Jun 16 15:50:08 EDT 2006 | Bert van den Berg

PSA - Pressure Sensitive Adhesive? I don't know which type of tape the affected reels of parts use but it is not sticky. Thanks everyone for the comments and suggestions. There were no missing teeth on the plastic take-up reels. I have cleaned an

Re: Fuji Feeder Alignment Tools

Electronics Forum | Wed Sep 08 16:56:06 EDT 1999 | Md Cox

| | | We are using some Fuji machines and have trouble picking parts up from damaged or mis-adjusted feeders. When I was working with Panasonic machines I was able to buy a feeder alignment jig from them to align the pick spot in the feeder, but Fuji

Fuji CP3 Tape Leaf Sensor

Electronics Forum | Fri Apr 24 07:27:28 EDT 2009 | jdengler

Hi Nick, I took a feeder that was broken and modified it. I glued shims in place to set the sensor height with. I glued a block of metal to work as a stop for the Y axis. Then for the rotation I use a piece of paper to see were the emitter is poi

Fuji CP643 equipment needed

Electronics Forum | Wed Jul 02 13:26:50 EDT 2003 | Terry Saunders

Hi, Terry!� Espi on our staff passed on your request to me.� I have attached a list of companies that offer previously used equipment.� You may want to try one of them.� You can also post this question on our Web site at http://www.smta.org.� Click o


fuji cp7/xp142 paper feeder searches for Companies, Equipment, Machines, Suppliers & Information