Electronics Forum | Wed Jan 05 10:22:55 EST 2005 | Mike B
We're getting an error on our CP643 that we can't seem to make sense of. It's a D1 axis error, but we're only getting it when we run a feeder on device 140. Any advice would be appreciated.
Electronics Forum | Wed Apr 22 12:50:39 EDT 2020 | rodrigo
Hi all, One of our Fuji CP-642 machines has a weird problem. It does not happen every time but often enough that it is a problem. I power up and press start to zero it. The problem is the zero...ing does not finish. It moves the xy-table, D1/D2 table
Electronics Forum | Thu Apr 03 12:36:30 EDT 2014 | jimmyboz
Hold the F1 key during power up, it will boot into the I/O screen. Check the 3 photo zones. Check the door switch. In the main screen you can cancel D1 or D2, then you can swap light sensors. Check carefully the wiring, there is a SYNC wire betwee
| 1 |
