Electronics Forum | Tue Dec 12 07:11:55 EST 2017 | esolano
Hi l have Yamaha YSi-12 AOI,I am looking error codes manual.lf any one have please advice. my id is atulpant@tekmart.com. Thanks Atul
Electronics Forum | Sun Aug 30 15:32:33 EDT 2009 | jimmyboz
most fuji error codes are 8 digits, A21E is 2100A21E, it is a report from the MCS that transmission has failed (we knew that) Hit control E from the main screen of the MCS, there should be another error reported from the cp6, ie. 1101000 is x data ou
Electronics Forum | Sun Aug 18 21:06:45 EDT 2019 | dman97
Based on the fuji error codes, It says that the ARCNET cable is disconnected. Make sure that all cables from this module are connected to the QP.
Electronics Forum | Fri Apr 23 02:15:36 EDT 2010 | smellew
Hi Rodrigo, Have you fixed your CP65? do you need some help? llew
Electronics Forum | Fri Apr 16 17:44:40 EDT 2010 | rodrigo
We're still trying to fix a C-axis overflow error in our CP-65. I was swapping servo boards and one of them started to blinks a 2 on the LED single digit display and the machine didn't boot up. I replaced the servo board with a spare we bought on eba
Electronics Forum | Sat Nov 07 18:38:32 EST 2020 | enzik
Hello to all, The Fuji GSP III screen printer was working well yesterday. This morning, the machine turned on and the display screen was showing nothing. I went to the back of the machine and reset one of the VM1152A. The display screen is now showi
Electronics Forum | Wed Sep 17 05:18:55 EDT 2008 | ralphspm
Our Fuji IP2 has a problem reading fiducial marks.It finds the mark(is shown on console display) but after time gives out the error statement "image display time over".It gives out an error status code of "FFFC" on the console display.Cannot find any
Electronics Forum | Fri Mar 02 14:00:39 EST 2018 | magergar
I have a problem with my fuji machine, it was working and then this error code appear: INTL SRV creation error Error Code:12037A20 and this shows every time on boot and doesn't let me do anything. what should I check?
Electronics Forum | Wed Jul 16 10:55:08 EDT 2003 | stepheno
You might want to check your input power. It is never "clean" but you might have too many spikes and transients. I've seen line monitors used and it was an eye opener how much noise there was on the input power. If you had a CPU go, you might want
Electronics Forum | Tue Mar 05 15:39:55 EST 2013 | orlando216
The servo itself has no code.