Electronics Forum | Fri Dec 15 20:51:01 EST 2023 | cyber_wolf
Calibrating the cameras on these machines is not something you can do "correctly" without the jigs from Fuji and following an exact method. It's been years since I watched a Fuji FSE do this, but I can assure you that unless it is done EXAC
Electronics Forum | Thu Dec 28 08:10:13 EST 2023 | vickey
Always follow the manufacturer's guidelines and recommendations when troubleshooting or performing maintenance on the equipment. If you're unsure about any step, it's advisable to seek assistance from Fuji's technical support or a qualified service t
Electronics Forum | Wed Dec 06 17:54:01 EST 2023 | madisreivik
Also, if someone has, please share camera adjustment procedure !
Electronics Forum | Thu Dec 28 18:55:04 EST 2023 | triplettx3
Have you tried calling Mike Forseen at SMT research? Very knowledgable on these machines.
Electronics Forum | Wed Dec 06 17:22:03 EST 2023 | madisreivik
Hello and help ! After changing oil hose, cleaning machine and all nozzles, CP642 narrow camera started to flicker. And in nozzle centering measuring, no image at all. We checked syncro pin, seems ok. Also checked camera picture with Sony monitor,
Electronics Forum | Fri Dec 08 18:02:21 EST 2023 | jdengler
Not sure on CP6's but CP2 through CP4 series used jigs. We now have an AIMEXIII and it uses jigs. I would bet that there are jigs for the CP6 series machines.
Electronics Forum | Sat Dec 16 09:43:39 EST 2023 | madisreivik
I know, but actually we have very "deep knowledge" of that machine, probably much deeper than we wanted :) So, if any information about nozzles please share !
Electronics Forum | Mon Dec 18 14:06:10 EST 2023 | cyber_wolf
I would check with these guys. One or both most likely have these jigs. http://www.ibesmt.com/ https://www.smtresearch.com/
Electronics Forum | Fri Dec 08 17:31:17 EST 2023 | madisreivik
Changed camera, flicker is gone. But cannot calibrate nozzle centers with the narrow camera, error all time I checked buffer image, brightness and contrast is SAME as with wide camera. Center of camera is roughly aligned using nozzle, its better
Electronics Forum | Fri Dec 08 19:02:12 EST 2023 | madisreivik
Found the main problem During messing around (hopelessly :) we had found the calibration menu and pressed "check". Machine thought that there was a calibration nozzle (maybe 10x10mm square) but in reality, there was d=1.0mm nozzle. Machine decided