Electronics Forum | Fri Jan 12 15:35:05 EST 2024 | madisreivik
On my CP642 I got narrow camera for 0201 parts. My question: some thick (2mm+) 0805 components look blurry. Is there a part height limit for the narrow camera ? I noticed that some parts predefined from previous owner were made to wide camera, alth
Electronics Forum | Tue Feb 19 09:19:01 EST 2002 | Kent
We have been placing 0201 in our production using both CP642 and CP643 since last year. But it was necessary to upgraded a narrow view camera to recognize 0201 for CP642. Since then, the placement of 0201 is really reliable.
Electronics Forum | Wed Jun 03 19:19:37 EDT 2020 | kurtiss
Hello, I am having an issue with a Fuji CP4-3 where during the nozzle center the image displayed by both the wide and narrow view camera is a black square. We have checked the cable coming from the 4400 Card and all checks out. We have also pulled t
Electronics Forum | Tue Jul 22 22:27:48 EDT 2008 | edmaya33
Our CP643E machine fails to recognise narrow view on its parts camera and confirmed that the VME48108 Picture processing board is the reason. The part number is AEEPN1603. Can anybody have the idea how much will it cost of i purchase a new one? How a
Electronics Forum | Mon Dec 18 21:23:13 EST 2006 | jgarver1
The spline shaft is bent. I have replaced a number of these over the years with the exact same symptoms. How is your placement? Your 180 degree placements should be skewed if the shaft is bent. 0 Degree placements are typically acceptable due to
Electronics Forum | Thu Feb 15 15:23:12 EST 2007 | bvdb
The IP-1 vision error is" "Processing Error" er 401F 4003 which the FIP-I Operating Manual says the cause is "The actual number of leads on the part exceeds the number of leads in the Part Data". I have checked and re-checked the part data, lead
Electronics Forum | Wed Apr 28 17:41:44 EDT 2004 | longpham246
Hello! We placed quite a few of 0402 with our CP3 using 0.7mm nozzle with the same feeder as you had. Pick up can be adjust and calibrated, but that is not the problem, I agreed with you on that part. The trick is you have adjust and play around wi
Electronics Forum | Mon Jul 14 11:59:41 EDT 2014 | rgduval
I've primarily used MyData equipment, personally, and, optically centered devices definitely take longer than mechanically centered parts on a MyData, owing to the construction of the machine. With a fixed upward looking camera, the head has to pick
Electronics Forum | Thu Apr 19 11:04:43 EDT 2001 | Spanky
All, We are getting ready to start running with 0201 passives. I have never run these before. We have run some 0402s however. We don't have any assemblies in-house yet, so I can't give any intelligent information regarding the board design (size,
| 1 |
