Electronics Forum | Thu Oct 29 17:43:46 EST 1998 | Guillermo Villegas
Does anybody know how to update a different nozzle than the standard one on a Fuji IP3 machine? I want to use a 15.8 mm height nozzle, but the limit on height size is 10 mm for IP3.I know, I need to use a special nozzle, so I�m trying with a 16.00 m
Electronics Forum | Fri Oct 30 18:47:19 EST 1998 | phillip hunter
| Does anybody know how to update a different nozzle than the standard one on a Fuji IP3 machine? | | I want to use a 15.8 mm height nozzle, but the limit on height size is 10 mm for IP3.I know, I need to use a special nozzle, so I�m trying with a 1
Electronics Forum | Wed Jul 17 09:25:54 EDT 2019 | andrewpayonk
When you transmit, I think the machine has to be set to 'offline'
Electronics Forum | Wed Jul 04 10:17:18 EDT 2012 | daxman
Good morning, Just a few questions to clarify: 1. You backed up your machine proper data. 2. You upgraded Fuji Flexa. 3. You re-transmitted the proper data 4. Now, components are not placing properly? Do you have a fuji 96-001 calibration board? Ha
Electronics Forum | Fri May 01 00:27:12 EDT 2009 | rodrigo
Hi all, We had a servo amp replaced (SA-6) and the machine worked with no problem for the first panel (this panel of 10 only needs a TQFP100 from the MTU). Then I got the "Servo NG" error again. One of the servo paks showed a "7" on the LED. The err
Electronics Forum | Tue Nov 20 06:19:42 EST 2007 | kircchoffs
just add FIP2 in fujiflexa when you are adding machine at factory lines. if you are connected just receive the proper data from the machine and re-transmit the proper data.
Electronics Forum | Mon Mar 16 12:22:58 EDT 2009 | dman97
Here is the screen shot. The program does generate with no errors. This is the only program to give me errors. All others transmit fine.
Electronics Forum | Tue Nov 11 13:25:17 EST 2014 | jimmyboz
I do not recall that "TEACH" ever worked. Even if it did, there is no way to save this data to the MCS. After you see that a fiducial cannot be found, change Xa-Ya in the program at the MCS to find it, and of course, re-transmit. Good Luck
Electronics Forum | Mon Oct 18 08:27:54 EDT 1999 | Bruce
buy a MCS-30, which you will use only to transmit programs to machines." If your really looking for the right software, contact Fuji about their latest software labeled FujiCam (Unicam). I don't think you can buy F4G software anyway. I guess it all d
Electronics Forum | Thu Oct 14 14:10:41 EDT 1999 | stefano bolleri
switch ALL your CAD/programming activity to F4G (throw away your current SW) --> buy a MCS-30, which you will use only to transmit programs to machines. Or does anybody know about a third-party SW that produces Fuji programs in CCIMF format? Or a co
