Electronics Forum | Thu Jul 21 01:29:07 EDT 2005 | matjen
We are using Fuji-Flexa software and we are not sure where to go in the software to check the proper data. If anyone has Fuji-Flexa software and could direct us in the right direction please let me know. Thanks.
Electronics Forum | Mon Aug 25 16:14:59 EDT 2014 | dman97
In Fuji flexa, under the machine configuration tab. Panel and Board mark reading order should be set to SKIP MARK. (this only works if you have the skip mark active in your fiducial list)If it is set to FIDUCIAL MARK, then the machine will ALWAYS pic
Electronics Forum | Wed Jun 29 19:33:12 EDT 2005 | matjen
After the machine stops for any reason when restarted the z table goes to loader position comes up then goes back down and re-reads the fiducials, only one machine does this but we are losing valuable cycle time after every part change. We have Fuji
| 1 |
.png)
