Electronics Forum | Sat Jan 31 00:59:59 EST 2004 | Eric
Hi, Do you have any office in Shanghai. If yes, appreciate you could get someone to present the machine to me. You can reach me at (86) 13764304372. My email address :- eric.chua@venture.com.sg
Electronics Forum | Mon Feb 02 22:05:35 EST 2004 | Dean
Hey Dave, you sound like my local board supplier...just kidding. Incomming inspection will protect you in these cases. Go no-go gauge is a simple as it gets.
Electronics Forum | Mon Feb 02 11:51:54 EST 2004 | jsk
error code: motor comms failure.card3, Axis123 fatal error-reinitialize machine I swapped x3 and x4, and still get the same error. Any suggestion would be greatly appreciated Thanks in advance, jsk
Electronics Forum | Tue Feb 10 12:16:40 EST 2004 | zaxx007
Dear Kratzman, We had one of their waves an 8FD and we had the worst time getting replacement pre-heaters, I would stay away, just my oppinion. Zack
Electronics Forum | Thu Feb 19 08:57:20 EST 2004 | northern
Has anyone ever seen a bulbous joint (on 1 side of 1 designator) on every board? I checked the preheat profile at the wave and have played with dwell times but can't get rid of it. I checked the archives and didn't find much. Any help would be apprec
Electronics Forum | Fri Feb 20 08:44:05 EST 2004 | davef
Lucky guess, eh? [Sorry to blow your theory on bad parts] A 1000 of these boards on the line, ummm. Two ideas to consider: * Increase the conveyor angle [don't get carried away, just keep the angle below 8*]. * Balance the flow of solder so that th
Electronics Forum | Tue Mar 09 18:14:07 EST 2004 | davef
We're not current in recommending suppliers, but we have discussed nitrogen storage previously here on SMTnet. Search the Archives to get started.
Electronics Forum | Wed Mar 03 07:26:16 EST 2004 | pjc
AP24X is old model. Some parts are getting hard to come by. Check if the vision system is Cognex 2000 or 5000 and what the computer is. It may have been upgraded. Otherwise, its a good printer.
Electronics Forum | Thu Mar 04 19:27:33 EST 2004 | russ
what I have usually found although not from wave conveyor chains but from racing motorcycles is that binding is caused by wear and bending and not dirt unless it is excessive to the point that you can actually see the dirt that is binding it. When t
Electronics Forum | Mon Mar 08 07:29:53 EST 2004 | mrmaint
Sounds like you have some delamination problems. How hot is the board getting? Try baking the board prior to rework. Is the quality of the board good? Goog Luck. MrMaint
