Electronics Forum | Mon Oct 05 21:25:19 EDT 2015 | ngineer
I have a quad qsv-1 machine that I'm trying to get up and running. I cannot get past the Q-Soft part where it wants to create an RT boot disk. I put my 1.44M floppy in drive A:, hit enter, it says it's creating the boot disk and then errors out say
Electronics Forum | Fri Feb 10 03:14:53 EST 2017 | soldertraining
Which is the best way to clean the PCB after soldering? Is it good enough with IPA (isopropyl) or with the Flux Remover spray? However, we use a lead free solder wire (3,5% flux inside the core) and after the soldering its a visible wet and surface g
Electronics Forum | Mon Apr 08 01:28:13 EDT 2019 | dunks
Hi all, Came across this machine that needs tlc. Hoping I can get it running smoothly. Will take any advice I can get. Seems like the only thing it needs is a thorough cleaning to run ok, and then a few parts to get it placing fine pitch qfp's and s
Electronics Forum | Tue Aug 13 23:09:25 EDT 2019 | action_101
The best one is NOT one of the guns that the sales reps had to be deceiving to get their promotional pitch in without being up front on who he was or the other rep who tried to capitalize on the other A-holes deceiving tactics.... RIDICULOUS Contact
Electronics Forum | Thu May 21 23:18:22 EDT 2020 | gabriel1blue
After the closing down for a few weeks we encountered a problem with our old pick and place machine. It reset to Japanese but we were able to change it back to English. Not when we start the machine and try to get it back to origin we get a counter o
Electronics Forum | Fri Jun 26 01:33:32 EDT 2020 | jmelson
> why not get an older essemtec or neoden? I > believe both run on 110V. Thanks so much for the Essemtec hint! Their Fox 1 really looks like it suits my needs! 18 mm component height, 50 um accuracy, small size, what's not to like? I'm go
Electronics Forum | Tue Aug 04 14:06:59 EDT 2020 | stephendo
Are you sure it is not a 240V transformer with a center tap? That is how residences are wired. If you use the center tap you get 120V. The other tap to center tap is 120V that is 180 degrees out of phase. So if you use the two outside taps you get 24
Electronics Forum | Sun Dec 12 17:06:33 EST 2021 | rajeevkul
Hello, We have a Philips CSM Comet II machine, now its hard disk is not getting detected and we tried to recover the data from that disk but we were unable to get the data. So, we are looking for software/data for the Philips Comet II machine. P
Electronics Forum | Wed Mar 08 07:47:00 EST 2000 | Tenison
I would get the board vendor to put rails on the board. Tenison Stone Telex Communications
Electronics Forum | Thu Oct 12 04:48:54 EDT 2000 | Marc
Does anyone know where I can get waffle trays for a PLCC44 package???