Electronics Forum | Thu Nov 03 14:43:19 EST 2005 | chunks
Hmmmm.... We never had to change any parameters when switching over to Gels. And no, we don't let the operators have kitty-wampus on our programs either. The Gels did get rid of broken parts. We have Run Orders of about 50 pieces. We change over
Electronics Forum | Thu Nov 03 04:17:07 EST 2005 | Slaine
we had the same problem of getting rid of the heat from the oven. we set up an air line to blow into the oven after parts had been removed that helped a bit. I dont like using them because the profile is not the same every time.So where possible i p
Electronics Forum | Thu Nov 03 10:49:11 EST 2005 | russ
This is what I would propose, Place and reflow the board without the BGA with your lead process, remove the solder from the BGA pads if you cannot mask off the apertures in your stencil. Then place the BGA and reflow to SAC requirements with a rewo
Electronics Forum | Sun Nov 06 13:12:17 EST 2005 | sk
Hello, I use Siemens MS128 & HS180. I need to place a lot of TO-252AA, SOT223, ... components. At the moment I use only mechanical centering but I want to center these components opticaly. There is no problem to center chips and other symetrical com
Electronics Forum | Tue Nov 08 16:44:15 EST 2005 | slthomas
If it makes you feel any better, we haven't done anything yet. All of our customers claim to be exempt. I haven't had time to look closely enough to verify, but right now I'll take their word for it. We ARE looking at upgrading our oven and getting
Electronics Forum | Tue Nov 15 06:46:41 EST 2005 | cyber_wolf
We have an earlier version of TPSYS. 2.4.1c We see this happen occasionally as well. It only seems to happen on our MY-12 machine. Our TP-11's never do it to my knowledge. I highly doubt that it is isolated to your company. If your machines are new,
Electronics Forum | Wed Nov 09 08:39:59 EST 2005 | smtspecialist
Thanks Avalancher. I had no clue about the fact that Mydata could analyze part for me. Since I'm in montreal it's hard and expensive to get a Mydata guy up here but sending the parts down there would be an great inexpensive solution. I've been over t
Electronics Forum | Thu Nov 10 14:38:27 EST 2005 | Proy
Does anybody here have any information or experience with a DEK249 DEK ALIGN II system made by Cybernetics robotics? This system moves the table to align it to reference images. We are getting an old system working, it is mostly there, but we are ha
Electronics Forum | Fri Nov 11 15:54:48 EST 2005 | Cmiller
We have an SPM with manual vision. Its the best manual printer we have ever had. I believe you can get one used for around 10K. If you buy a realy old one, make sure it has the air table lock!!! I think they only made a few that didnt.
Electronics Forum | Mon Nov 14 08:19:19 EST 2005 | cguerrero
Has anyone had issues with their glue stations. After our software upgrades it seems to not be working properly. We have had it slam into the pot, not go into the pot, slam the arm, etc.. Default glue dots used to work now I have to set all their bi