Electronics Forum | Tue Feb 14 03:58:17 EST 2006 | Rob
Yes, it's fine - as Pete says you have to replace certain parts & either get the pot recoated or a new one. We ran a "Lead free" 6622C from Vitronics Soltec on Tin Lead, then it was cleaned up, recoated and loaded with a no-lead alloy with no proble
Electronics Forum | Sat Feb 18 20:46:45 EST 2006 | Brian
Hey, Been looking at Brisbane, hoping there is enough SMT going on to be able to get a job there. Noticed a lot of manufacturing seems to be in NSW though... Staying clear of Sydney due to cost of living and Perth due to remoteness. Where do y
Electronics Forum | Thu Mar 02 21:23:30 EST 2006 | Wave Master Larry
Well see you wrong. I've done this kind of thing for 12 years and I cna tell you that suporting boards with anything else will cause more problems. wave is an art tha needs to be respected even by engineers at AI. Once you get the process down the
Electronics Forum | Mon Feb 20 08:25:13 EST 2006 | Rob
No problem. If you get no joy you're going to have to change the footprint to a 1206 or 1210. Murata have a range of high Q value inductors (50-60) & from memory Toko used to be pretty hot too. The terminations on the coilcraft part are listed a
Electronics Forum | Tue Mar 07 11:13:04 EST 2006 | pjc
One difference with ECD from a hardware standpoint is that the M.O.L.E. installs into the OvenRIDER, WaveRIDER and ReworkRIDER products for solder machine process control. You get the same software too. Competitive systems I believe require more hard
Electronics Forum | Wed Feb 22 21:27:04 EST 2006 | gcolbert
Our solder paste machine has a squeegee problem. After passing over a board, the squeegees don't go all the way back up to their origin state. Then we are getting a timeout error and have to return the machine back to its origin (manually), and pass
Electronics Forum | Thu Feb 23 19:03:38 EST 2006 | russ
We should be getting close to a new "deadline" huh? what is going to happen in Europe when the day comes and "it just aint ready" Will they actuall stop importing and using? I have not read the directive for all of the little nuts and bolts so thi
Electronics Forum | Fri Feb 24 15:12:20 EST 2006 | Chunks
I like Ticky Ticky Tembo No Sarimbo Hari Kari Bushkie Perry Pem Do Hai, who just posted here lately. Get right to the point. I don't think your "cool" name was stressing people out - more like it "dehumanizing" them! (I was accused of doing the sa
Electronics Forum | Fri Feb 24 15:15:33 EST 2006 | russ
The No-Clean indium lead free paste runs well. We discontinued because of extremely high shipping costs. We can get the same results with cheaper product. Almost all of the discussion in this forum about SAC305 and SN100C have to do with wave sold
Electronics Forum | Fri Mar 03 02:07:22 EST 2006 | revive
Hello everyone. I have around 1200 ICs that needs reballing. I don't plan to tackle these ICs myself. Therefore, anyone know of any companies that have a good/quick/cheap reballing service? And can anyone give me a ballpark figure on the service
