Electronics Forum | Sun Jul 10 15:25:20 EDT 2016 | bradholland
hi martin, i can help with the manuals. I just got a 740 myself and am completely new to it all. Have been learning the machine over the last couple of weeks and have it now placing my board quite nicely. however, for all my 0603 resistors, it seems
Electronics Forum | Wed Aug 24 22:11:36 EDT 2016 | davef
I'd guess that "black pad" is not the issue that you need to address, because only 2 of your 5 test points has the problem that we seem to be discussing. I'd expect "black pad" problems to be more wide spread. Something is going on at those two locat
Electronics Forum | Wed Jun 29 16:30:48 EDT 2016 | proy
We have been studying and learing how to work with an older Seica Pilot (S20 software) flying probe tester. A third party company has been very helpful but they are not that familiar with the S20 software. Looking for someone with knowledge of the S2
Electronics Forum | Fri Sep 09 06:03:37 EDT 2016 | jswatt
Simple answer is no you cannot do it and why would you?.. is it a cost saving thing? As Dave F correctly points out you have a fair amount of noxious fumes to handle that aren't getting exhausted if you switch of the extraction so they will go to you
Electronics Forum | Tue Jul 19 18:08:28 EDT 2016 | dman97
Hello, I am having trouble getting our old CP3 to start up. When the machine starts to run, or when we try to center the nozzles, the CAM moves to 300 degrees and stops. The station 5 rotor just turns and turns with out ever centering the nozzles.
Electronics Forum | Thu Jul 21 14:54:32 EDT 2016 | ttheis
Acetone is flammable and hazardous to deal with. The fewer fire hazards and nasty fumes the better in my opinion. I would either go with a alcohol based no-clean for economical processesing and boards that can't be washed, or water washable if you ca
Electronics Forum | Thu Aug 18 09:41:05 EDT 2016 | jbuckley
Typically on my company's Mirtec systems, any anomalies, such as cracks, chips, etc. on chip capacitors and chip resistors are going to be detected with just a basic mounting inspector. We have a full image of the part (solder joint not included) as
Electronics Forum | Thu Aug 25 17:24:44 EDT 2016 | davef
Gold should not be corroding in salt water. I have swum hundreds of miles in salt water with my wedding ring on my finger. My ring is a shiny and corrosion-free as the day it was cast over 120 years ago. It's possible that your gold thickness of 0.0
Electronics Forum | Fri Aug 26 19:59:02 EDT 2016 | mhanrahan
We've just purchased a CP45FV Neo to replace an ancient Panasonic line. First non-Panasonic placement equipment I've worked on, so learning as I go here. So far it's been pretty straightforward. However, we use some parts that come in QFN or LCC p
Electronics Forum | Wed Aug 31 09:45:36 EDT 2016 | ttheis
I have a smema conveyor connected to the downline fmi connection on my up500 but the fmi sugnals show the coneyor ready signal going ro the upline ready input (screenshot). The downline ready output is activated qhen a board is output from the printe