Electronics Forum | Fri Jan 31 12:22:10 EST 2003 | TN
Many companies used the Fuji CP-4 and CP-6 chip shooters, these are good for the small components like resistors, caps, diodes, transistors and small IC's. If you have BGA, QFP or other larger odd components you will need to go with another type of
Electronics Forum | Fri Jan 31 14:35:48 EST 2003 | russ
I would go for the laminar flow as opposed to N2. The contour nozzle doesn't really work all that well even with N2. I knew I should of asked you if you had a contour, I was thinking laminar flow hence the dynamics input. Russ
Electronics Forum | Fri Jan 31 13:44:52 EST 2003 | MA/NY DDave
Hi Wow, I can't imagine what's going on here. The balls are obviously high temp stuff. Email me a site to look: ddaveyie@yahoo.com YiE, DDave
Electronics Forum | Wed Feb 05 11:26:57 EST 2003 | pjc
Arguably the finest axial lead cut and form machine ever created. They go for like $25K new. Can do almost any type of form. Good German engineering!
Electronics Forum | Mon Feb 10 10:20:02 EST 2003 | bdoyle
Sorry I didn't notice this one last week. Also nobody notified me about it. Anyhow I'm actually going to leave it because of the good responses. Everyone please remember to email me if you find a post offensive.
Electronics Forum | Thu Feb 13 09:34:33 EST 2003 | genny
Did it take you to the magazine website? Just scroll down to where it says magazine on the left side, choose past issues and pick January. I think it was the featured article. Or try this to go right to that article. http://www.circuitsassembly.com
Electronics Forum | Wed Feb 26 10:57:47 EST 2003 | larryk
Dave, I had to contact Circuits Assembly, but I got the article. I'm going to forward it on to Ryan. I think you're on to his problem with flux becoming entrapped in the epoxy. It plays along with Locktites suggestion of a longer soak on his profile.
Electronics Forum | Tue Feb 25 17:46:35 EST 2003 | davef
And the really sad part about that is: Some organizations actually REQUIRED a institutionally myopic organization like the FDA to go "Hello, design has a BIG impact on quality and you HAVE to pay more attention to that area".
Electronics Forum | Thu Mar 06 10:32:18 EST 2003 | pjc
Go to http://www.cooksonee.com/products/electrovert/Wave/Dross/index.htm for the Cookson Electronics Equipment- Electrovert- Integrated Dross Management System
Electronics Forum | Sun Mar 09 16:11:38 EST 2003 | Neil
I agree, with Dave what is your top 3 defects and what causes them? Most post reflow defect are already on the board before they go into the oven, all the oven does is expose them.