Electronics Forum | Thu Oct 07 20:34:48 EDT 1999 | Tony Huang
Hi, Does anybody know what is the minimum gold plating thickness on the PCB goldfinger required by the industrial specifications - IPC, Bellcore, etc. Where can I find the information? Appreciate for the help! Thanks, Tony
Electronics Forum | Fri Oct 08 17:12:31 EDT 1999 | Dave F
| Hi, | | Does anybody know what is the minimum gold plating thickness on the PCB goldfinger required by the industrial specifications - IPC, Bellcore, etc. Where can I find the information? Appreciate for the help! | | Thanks, | Tony | Hi Tony:
Electronics Forum | Thu Jul 10 09:16:41 EDT 2008 | aj
Hi all, What should the typical gold thickness be on ENIG boards ? aj...
Electronics Forum | Fri Jul 11 08:17:22 EDT 2008 | aj
Hi Dave, Yes that is correct. I had a XRF carried out on some boards that I am having solderability issues on and the report came back with 0.04um - 0.05um as the measured gold thickness. Previous batches that went through fine measured 0.07-0.11u
Electronics Forum | Tue Jul 15 16:30:57 EDT 2008 | boardhouse
Hi Aj, Recommended Immersion gold thickness would be 3-5 Micro inches over 140 -200 micro inches of Nickel. Thicker Immersion gold than 5 micro inches can cause solder joint embrittlement. Gold readily dissolves in molten solder and will be present
Electronics Forum | Mon Jul 28 06:23:29 EDT 2008 | cobar
Please look up http://www.shanelo.co.za/Black%20Pad%20Index.htm and check out the article named"Soldering to gold a practical guide."
Electronics Forum | Thu Jul 10 22:19:14 EDT 2008 | davef
Search the fine SMTnet Archives to find threads like: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=33661
Electronics Forum | Fri Jul 11 02:42:40 EDT 2008 | aj
Thanks Dave, IPC-6012 states min at 0.05um. Has this been a update or is it for a different class? thanks, aj...
Electronics Forum | Fri Jul 11 07:04:26 EDT 2008 | davef
2 uinch, right? Here is the revision level for IPC documents: http://www.ipc.org/4.0_knowledge/4.1_Standards/revstat1.htm
Electronics Forum | Wed Aug 11 16:09:50 EDT 2004 | Kris
Hi How does one distinquish between hard gold and immersion gold ? thickness is 4 to 10 u" for Au and 300 to 400 u" for nickel what happens if the gold drops below 3" and the nickel is above 350" what are the typical failure modes associated with
