Electronics Forum | Sat Oct 24 07:55:55 EDT 1998 | Chuck Garth
I know that this not surface mount, but many of us have to perform multipule duties. Can anyone give me some information on this I am having problems getting relibility getingthe heat seal ribbon to make consistant electrical contact. Any help would
Electronics Forum | Tue Oct 27 10:40:32 EST 1998 | Greg Curler
| I know that this not surface mount, but many of us have to perform multipule duties. Can anyone give me some information on this I am having problems getting relibility | getingthe heat seal ribbon to make consistant electrical contact. | Any help
Electronics Forum | Sat Oct 24 23:30:59 EDT 1998 | Pete Sorenson
| I know that this not surface mount, but many of us have to perform multipule duties. Can anyone give me some information on this I am having problems getting relibility | getingthe heat seal ribbon to make consistant electrical contact. | Any help
Electronics Forum | Thu Aug 31 18:59:55 EDT 2000 | Brian W.
Our customers use OSP, HASL, immersion tin and immersion gold as board finishes. If I recommend a finish to the customer, it is one of the immersion finishes or OSP. Those finishes have the advantage of a flat surface to deposit paste. HASL has va
Electronics Forum | Tue Jul 28 07:02:59 EDT 1998 | smd
Right now we are taping the goldfingers which is effective but also expensive. Also, some tape was leaving yellow marks on the goldfingers. We're trying the so-called goldfinger glove from Steven's Products. It's a very small company (probably one gu
Electronics Forum | Mon Aug 03 08:29:24 EDT 1998 | Dave F
SMD: Sounds interesting. What is the contact information on Steve? Dave F | Right now we are taping the goldfingers which is | effective but also expensive. Also, some tape was leaving yellow marks on the goldfingers. We're trying the so-called go
Electronics Forum | Sat Sep 16 03:09:35 EDT 2000 | Sartor
I am in trouble with gold finger cleaning and repairing.Can anyone recommend good solutions?Also,can anyone recommend a good flux paste source(s)?Thanks.
Electronics Forum | Fri Jan 30 10:29:48 EST 2009 | petep
We have a potential new customer who has special PCB requirements. I do not know a lot of details at this point, but have several questions. One of their assemblies has within it , a MID, Solid foil layer, completely isolating one side of the PCB f
Electronics Forum | Mon Oct 24 05:43:52 EDT 2016 | zxcvb
I have many PCBs that use an AVR in SMD packaging, and since I frequently change the firmware in prototype boards, I'm trying to come with the best solution to program the AVR quickly and easily. The first approach was to have a standard header (2x5
Electronics Forum | Fri Sep 08 04:45:17 EDT 2000 | PeterB
As per Travis's reply it could be something other than the reflow process. Another good one is if the printed PCB's have been cleaned down due to print misregistration etc.. If not properly controlled paste residues can remain distributed about the p
| 1 |
winsouce.jpg)