Electronics Forum | Wed May 09 10:56:52 EDT 2018 | rickeydad
I would like to know the hardness figures of ENIG finish and hard gold finish. I can find the hard gold finish number and it appears to be 130-200 knoop. But what about ENIG finish?
Electronics Forum | Wed May 09 17:28:25 EDT 2018 | davef
You can't find a hardness spec for immersion gold [ImAu] because no one cares. The ImAu dissolves into the solder during thermal processing. Pressed, I'd guess for that ImAu hardness is about that of soft gold * Soft: 50-90 knoop * Hard: 130-200 k
Electronics Forum | Mon Aug 16 16:37:08 EDT 2004 | davef
As we mentioned in an earlier response in this thread [Q5], you do NOT want to solder to hard gold. Hard gold is a wear surface. [That's IT, that's the LIST.] If you want to solder to gold, then either use: * IPC-4552 ENIG specification, mentioned
Electronics Forum | Wed Aug 11 16:09:50 EDT 2004 | Kris
Hi How does one distinquish between hard gold and immersion gold ? thickness is 4 to 10 u" for Au and 300 to 400 u" for nickel what happens if the gold drops below 3" and the nickel is above 350" what are the typical failure modes associated with
Electronics Forum | Thu Aug 12 14:50:12 EDT 2004 | russ
This is interesting, I was once told by a PCB supplier that "soft gold" was immersion and the "hard gold" was the plated. But I agree with Dave F., Chris, what's going on? Russ
Electronics Forum | Mon Aug 16 13:18:46 EDT 2004 | davef
You bet our reponse changes. Q2R: Hard gold thickness is 4 to 10 u" for Au and 300 to 400 u" for nickel A2R: This is a hard gold spec?? It looks like a ENIG spec. Although, the Ni is quite heavy, 150 uin is sufficient for most applications. The gol
Electronics Forum | Mon Aug 16 11:49:44 EDT 2004 | Kris
Hi Guys thanks for the replies. Dave, the spec is not for enig but for hard gold does your response alter if thats the case /
Electronics Forum | Wed Aug 11 18:36:03 EDT 2004 | davef
90 Knoop. Q2: Thickness is 4 to 10 u" for Au and 300 to 400 u" for nickel A2: This looks like a ENIG spec. Although, the Ni is quite heavy, 150 uin is sufficient for most applications. [IPC-4552 ENIG specification: * Gold thickness of 0.075 - 0.125
Electronics Forum | Thu May 02 09:33:30 EDT 2013 | 15009
Looking for advice on soldering lead free paste to a board with very heavy gold plating. I have learned from the Customer that this is HARD GOLD and that it is 10-20 Micro Inches Hard Gold over 100 Micro inches of Nickel. When we reflowed the solde
Electronics Forum | Wed Jul 31 18:26:09 EDT 2013 | Jeff Kennedy
You might consider to contact a lab to Run a microindenter against a know good soft gold sample. The knoop value for the soft gold will be much lower than for hard gold. This would be reflected in the diameter measurement of the indented samples.Smal