Electronics Forum | Thu Mar 14 18:16:58 EDT 2013 | isd_jwendell
With those interlocks tested, and confirmed good. I would check the end-of-travel safety switches next. It may think that the head is at the end of it's travel.
Electronics Forum | Wed Apr 03 19:27:41 EDT 2013 | jorge_quijano
Good advices. What do you think of using a gravity paint spray gun? somebody recommend it to me, it will still depend on the operator but at least it would be more constant.. make sense? Saludos
Electronics Forum | Thu Apr 18 14:09:57 EDT 2013 | bobpan
Just because a feeder has 8 pins on the front does NOT mean it is IQ. The IQ feeders started at a certain level of feeder part number.....which i do not remember being that many people dont use the IQ system. Good Luck
Electronics Forum | Thu Apr 25 12:26:35 EDT 2013 | emeto
Hi, I was using different brand machine but it will behave the same way as yours when it is dirty or clogged. Try to clean your nozzle and your supply mechanism(pump, propeller...) and you should get a smoother wave. Good luck!
Electronics Forum | Tue May 07 15:30:41 EDT 2013 | bobpan
your card is probably bad.....you can ohm out the motor and cable if you want... z motor windings 1.36 ohms z motor cable and windings 1.82 ohms good luck
Electronics Forum | Tue May 21 13:38:04 EDT 2013 | CJTech2X
Anyone know a good North American source for Assembleon feeders? Specifically 24mm with a 12mm+ depth? Also looking for 16mm, 12mm, 32mm, and 44mm.
Electronics Forum | Mon Jun 03 12:53:48 EDT 2013 | emeto
Hi, it should be good for fixtures. I reads that somebody made gun with one of these and it actually worked. Now the security everywhere are thinking about ways to catch plastic weapons.
Electronics Forum | Mon Jun 10 08:13:48 EDT 2013 | bobpan
Check to make sure the side covers are closed. It is probably an interlock problem. Also if you have carts...make sure the plunger switches are down. Good Luck
Electronics Forum | Mon Jun 17 06:56:50 EDT 2013 | bobpan
Did you teach the reject mark? Sounds like a lighting issue when looking for the white sticker. You can also skip images by pressing control-repeat after the machine has found fiducials. Good luck
Electronics Forum | Tue Jun 18 17:08:41 EDT 2013 | rway
I think 3 months is over-board as well. If it needs to be done, I would do it on an annual basis. I have performed similar maintenance on our machines, but yearly. But if not, when you exhibit problems, this would be a good place to start. So doi
