Electronics Forum | Thu Oct 16 14:12:36 EDT 2008 | evtimov
Hi, I think the standard was IPC 6850. But I will recommend to go directly with the sigma test. Place parts with the machine and measure the placement accuracy on another machine. 4-5sigma at 50um should be a good machine. If they have sigma in thei
Electronics Forum | Fri Oct 17 04:23:51 EDT 2008 | fujiphil
Check the image using the fast inching [F] and axis selection [2]. After vision error, press [F] then [2]. The monitor will display a binary images. You will now have a visual look on how the error occurs. Adjust the CCD level of the camera until you
Electronics Forum | Fri Oct 17 17:08:52 EDT 2008 | fsw
Where is your geographical location? It is important as we have a local company with a good MRP software that is reasonably priced & is price is not linked to number of users. Contact me @ dfwadia@yahoo.ca for further details. I am not a sales person
Electronics Forum | Thu Oct 23 11:11:46 EDT 2008 | bobpan
Ok, been a long time so dont quote me on this.....but i think you have to go into assembler configuration and change a number that is located under each assembler to its own number....ex....assembler 1 assembler 2 . They probably both have a 1 at t
Electronics Forum | Tue Oct 28 13:00:56 EDT 2008 | exman
ax-5 having problem with pickup problem when the head placement try to pickup the component on the feeder the toolbit will fall off eventdo teach the part center very good but when they pickup it off about one inch happent on ly robot #1 the rest of
Electronics Forum | Tue Nov 04 04:00:38 EST 2008 | Martin
Hi All, Anybody knows good, repetable method of dispensing flux for micro BGA rework? 6x6 mm(0.5 mm pitch) The flux dispensing amount by brush may vary depending on operator etc. If operator dispense too much flux the BGA "swim".Around the BGA compon
Electronics Forum | Fri Nov 14 17:37:58 EST 2008 | snsmt
WHat about bad mounting? i have 2 fixtures and sometimes it would mount with no misalignment and sometimes it would. WHat could be the problem in this case/ I know the fixtures are good because they work on a different program that we have. I don't u
Electronics Forum | Sat Nov 15 08:15:48 EST 2008 | davef
So next time that you order boards from your fabricator, consider asking the your fab to cap these pesky via on the solder side with SR1000 [or whatever they think will be good and cheap]. Think of the money you'll save. Your boss will be ecstatic!!!
Electronics Forum | Fri Nov 21 18:28:42 EST 2008 | Frank
In the good old days, I've made raw boards at home. Layout the design and then transfer it to a bare copper clad board. Etching it out is the fun part. I grabbed our 9x13 pyrex baking dish from the kitchen. Using metal etching dish doesn't make
Electronics Forum | Tue Dec 09 18:11:06 EST 2008 | davef
Just to keep this up in the air, go to the http://www.ipc.org free download section. There is a contract assembler questionaire that could be a good starting point for what you seek to accopmlish. Check it, get back to us and maybe we can use that as