Electronics Forum | Thu Apr 26 21:09:14 EDT 2001 | davef
Hey Wolfgang: I was down at Jimbo's and tried a McEwan's Pale Ale, yech!!! And Scotch beer [eg, McEwan's Scotch Ale, Tennant's] has been so berry, berry good to me, helping to sauve the travails of winter, until I could starting working on wheat be
Electronics Forum | Sun Apr 29 15:43:38 EDT 2001 | davef
Call me wet behind the ears!!! I'd kinda like to see you refine your processes on your products before you go-out drying-out your ears on someone else's products. The worst contractors in the world seem to be those with their own product lines and
Electronics Forum | Thu May 03 09:55:36 EDT 2001 | davef
First place: Try Genrad, but you probably have a good story why you don't want to do that, eh? Second place: Try an used ATE reseller / refurbisher like: * Denver Test Systems 12253 E Alaska Pl Aurura, CO 80012 303 341 7566 fax 0378 Karol Shure
Electronics Forum | Thu Oct 26 08:59:57 EDT 2000 | ptvianc
Performing a wetting balance test would be very difficult. The flux cored wire "configuration" is just not compatible with the methodology of the wetting balance test. If the wetting balance is a must, then you might ask the vendor for the flux for
Electronics Forum | Thu Jun 22 17:05:52 EDT 2000 | Lee
Actuallly, think ISO14000 does not really take this approach except in the sense that it does specifically serva as a tool for companies to monitor and control their environmental impact. One expert who contributed to my book explained it to me this
Electronics Forum | Thu Jun 22 16:59:18 EDT 2000 | Lee
I'll be real brief, because of time, but feel free to contact me later (lgoldberg@chipcenter.com). There is big conceren (somewhat well-founded but a bit overblown) about lead form electronics products leaching into the environment when they are land
Electronics Forum | Wed May 09 11:25:29 EDT 2001 | medernach
What type of preheaters do you have on you're wave? I have to agree with Dave. Your leads are not cold, they are hotter than the annular ring on the PCB. This would cause the solder to go to the lead only rather than the component and land pad / a
Electronics Forum | Tue Jun 04 19:33:16 EDT 2002 | rob_thomas
Dave's estimation is pretty conservative but there is a lot of equipment out there and a lot of people happy to make a sale.Implementing both mentioned processes it's difficult and time consuming .Even if you get good training from whoever sells you
Electronics Forum | Tue May 22 23:49:58 EDT 2001 | jones
I've never tracked the life of a stencil, but if your seeing an decrease in the life of your stencil you may want to look at the printer itself. What kind of printers are you using? I'm more familiar with MPM screen printers and I have seen were cert
Electronics Forum | Mon May 14 19:16:49 EDT 2001 | jagman
Dave: Actually, I'm located in the South Bay (Santa Clara)! Good guess. Now, for more in-depth information: So far, the distribution has been limited to one board out of 10 assembled, so far from one lot. The components assembled are exclusively