Electronics Forum | Mon Jan 02 23:50:24 EST 2006 | grantp
Hi, Just wondering while reading this thread, would 0402 caps be more immune to stress because they are smaller? Regards, Grant
Electronics Forum | Fri May 19 13:40:36 EDT 2006 | grantp
Hi, Sorry to drag this thread up again, but we were recommended to change the wave to SAC305, but is everyone recommending SN100C? That seems to be the feeling on this thread. What flux is used? Regards, Grant
Electronics Forum | Thu Jan 05 15:15:08 EST 2006 | grantp
Hi, Really? Where are those? Can you post them on the lead free thread that's currently running? Regards, Grant
Electronics Forum | Mon Jan 09 08:25:30 EST 2006 | grantp
Hi, If the stencil was not cleaned well from the previous run, dried paste residue can cause the paste to grab in the stencil. If you have a microscope, check the small apertures for contamination. Regards, Grant
Electronics Forum | Mon Jan 09 11:26:08 EST 2006 | abhinavajmera
Dear Grant, Thank you for the reply. It is really a valid reason and I did check for it but nothing turned out that way. Can you think of some other reasons if the process parameters are the same used earlier when there was no problem at all. Regard
Electronics Forum | Tue Feb 07 17:47:30 EST 2006 | grantp
Hi, I would say the most worrying defect would be damaged parts due to exceeding their temp specifications. Regards, Grant
Electronics Forum | Mon Feb 13 06:03:25 EST 2006 | grantp
Hi, Does it really matter what temp the oven runs at as long as the PCB's are profiled correctly? I mean we run boards through all the time to check profiles, so as long as that's ok, would it matter what the oven though the temps where? Regards,
Electronics Forum | Fri Feb 17 09:24:22 EST 2006 | Rob
Cheers Grant, I found that very helpful too - we're going over end of this year to take a closer look at Aus & NZ (my other half was over there a long while). Thanks, Rob.
Electronics Forum | Fri Feb 17 16:41:33 EST 2006 | Brian
Thanks Grant, Don't suppose you can guide me to a web address for that company ? I can't seem to find it on Google.. Thanks, Brian
Electronics Forum | Thu May 18 08:38:07 EDT 2006 | jdengler
Grant, I think this Guru has never set foot onto a production floor. He just looks at data from the machine manufacturer. As you have found out the hard way this data is not the full story. Jerry