Electronics Forum | Wed Jun 30 20:32:44 EDT 2021 | rgduval
Check the friction numbers...there could be an issue with the z-wagon bearings, or something else adding tension to the z-travel. Also make sure there are no cables interfering with the z-travel. Could be a cable that moves into the way at some spe
Electronics Forum | Thu Aug 05 17:32:31 EDT 2021 | cyber_wolf
Including non-spring tools ? Additionally I assume you know how to use the tool install utility and have looked for things like cracks in the big ribbon cables on the X ? Tools are not dry and have white grease on them etc ? There is a show force
Electronics Forum | Fri Aug 06 14:01:53 EDT 2021 | tomdegas
Unfortunately all my tools are spring loaded. Yes I do know the tool install utility. I have been running and maintaining the 3 MyData machines for over 20 years and I never saw an error like this. I grease our tools once a month so I know that is
Electronics Forum | Wed May 11 17:25:22 EDT 2022 | SMTA-64387687
You've replaced the sensors and cleaned any grease residue inside the Midas head, and you're still getting this error. You can check the connector on the little board, on top of the Midas, where the flex cable plugs in. I don't remember, off the t
Electronics Forum | Thu Sep 22 10:04:33 EDT 2022 | micropak
Good Morning, I have a Phoenix PCBA Analyzer 160KV with NanoFocus tube. The machine warms up till 104KV only (it gets some breakdowns around 100KV) and then it finishes warmup but doesn't go beyond 103KV while doing inspections. HTG Cable has been gr
Electronics Forum | Thu Mar 28 14:28:26 EDT 2024 | kingkelvin
We have MY9 - when it changes hydra tooltips - most of the time it makes a small "hitting" type noise - with error F-MOT MOVESLOWMOVE HYDRA Z/205 - however you can just hit continue and it will always change the tools and finish the board - I've un-i
Electronics Forum | Wed Jan 23 11:28:47 EST 2008 | tbkonrad
Help! Since last Friday i have been having issues with a Quad qsv-1, it all started with a quad align error, i found there to be a small quantity of grease covering the lenses on both quad align sensors. I wiped the grease off and then everything s
Electronics Forum | Tue Jul 07 08:11:06 EDT 2009 | cyber_wolf
Biral T&D has to be purchased directly from Biral Norway. We recently successfully purchased a case. I have found that oils and greases are shrouded in a "veil of black magic". I have gone over this time and time again. My opinion is that 99.9% of t
Electronics Forum | Sun Mar 07 09:24:55 EST 1999 | Scott Cook
| Hi Ya'll... | it's a Soltec Prisma and the conveyer keeps jamming. What it's doing is up at the exit end where the drive motor is, the chain keeps wrapping itself around the drive sprocket and jamming...this is on the backside rail, the frontside
Electronics Forum | Fri Jan 05 09:23:10 EST 2001 | Brian Toleno
While there may not be any specific requirement to cleaning prior to coating, cleaning an assembly prior to coating will only serve to increase the reliability and integrity of the coating. Some residues from low-solids fluxes can interact with conf