Electronics Forum: grid-lok (Page 1 of 12)

UP2000 with grid-lok question

Electronics Forum | Wed Jan 24 12:27:21 EST 2007 | Tyrone Jamal Washington

This option sounds like it defeats the purpose of Grid-lok.

UP2000 with grid-lok question

Electronics Forum | Wed Jan 24 08:12:21 EST 2007 | Hussman

Turn off Grid-Lok, turn off side clamps. Use hand inserted tooling (yeah, you may have to do some thinking here)for support. If you have vacuum, turn it on. People still use Grid-Lok?

UP2000 with grid-lok question

Electronics Forum | Wed Jan 24 13:25:26 EST 2007 | pr

Grid-lok only supports the board, so why would what I suggested defeat the purpose of the grid-lok? You still falling down when you mark your golf ball, Tyrone?????

UP2000 with grid-lok question

Electronics Forum | Tue Jan 23 15:20:59 EST 2007 | stepheniii

On the Ekra those are called top clamps AKA finger slicers. With the Ekra side clamping means there is nothing on the top of the board. Does your printer have true side only clamping? Or do you need the top finger slicers for the grid-lok to work r

UP2000 with grid-lok question

Electronics Forum | Wed Jan 24 11:22:46 EST 2007 | pr

Do you still have the vacuum plates in? If so, you can set the grid-lok up in the "fixed mode" (not sure what they call it,where it won't set for each board), then you could run without side clamps and the Vacuum should be enough to keep it from movi

UP2000 with grid-lok question

Electronics Forum | Wed Jan 24 13:46:07 EST 2007 | Tyrone Jamal Washington

Man I don't play no golf.that's a white man's sport!

UP2000 with grid-lok question

Electronics Forum | Wed Jan 24 13:57:49 EST 2007 | pr

WORD, you can't play no golf!!!

UP2000 with grid-lok question

Electronics Forum | Wed Jan 24 14:09:25 EST 2007 | Tyrone Jamal Washington

man you wacked!

UP2000 with grid-lok question

Electronics Forum | Wed Jan 24 16:23:12 EST 2007 | Phlip Kid

wacked like Jay-Z drinkin a Bud!

UP2000 with grid-lok question

Electronics Forum | Tue Jan 23 07:18:24 EST 2007 | cyber_wolf

Hi, We have a UP2000 with grid lok installed on it. We run several assemblies that have component pads close the edge of the board. The side clamps hold the stencil up off the board and we are either getting insufficients or excessive solder paste in

  1 2 3 4 5 6 7 8 9 10 Next

grid-lok searches for Companies, Equipment, Machines, Suppliers & Information