Electronics Forum | Mon May 02 15:59:46 EDT 2016 | donpito
Hi any of you guys has happened this error in GSM and machines as they could fix it " AXIS X2 Error Not Recognized During move home command"
Electronics Forum | Thu Jul 13 14:21:21 EDT 2006 | bigdaddysoy9
I just had these errors the other day. The problem was the Z axis drive belt was chewed up.
Electronics Forum | Thu Jul 13 15:14:27 EDT 2006 | SWAG
I'll check that - easy fix if so true... Thanks.
Electronics Forum | Tue May 03 22:55:53 EDT 2016 | ttheis
Also it might be a failed axis controller card in the VME; check for any red fail lights.
Electronics Forum | Wed Sep 19 16:20:46 EDT 2007 | highspeed
Can anybody tell me what an error code 6 means after a GSM Calibration.
Electronics Forum | Wed Jul 12 16:39:59 EDT 2006 | SWAG
Can anyone help point me in the right direction on fixing problems related to the following Universal GSM2 errors?: 1) Axis head 1 Z position following error during Move Absolute command. 2) Axis head 1 Z error not recognized during Move Absolute
Electronics Forum | Mon May 02 23:26:12 EDT 2016 | ttheis
Is this a dual-beam GSM2? Check to make sure the machine configuration is correct for the machine, otherwise I would look at encoders for the axis and electrical connections.
Electronics Forum | Tue Mar 22 14:50:11 EDT 2016 | ttheis
A friend of mine has a used gsm1 but when loading up UPS it gives an error indicating it did not receive a request to load the machine model in the allotted time. Photo is attached of the message. Any suggestions what to look at? The machine is runni
Electronics Forum | Tue Mar 22 22:42:18 EDT 2016 | ttheis
Apparently the machine is now completing initialization but when attempting to zero axis' it has a time-out waiting to change modes. Machine status page shows an error reading "initialization failure for motion control board."
Electronics Forum | Sat Oct 03 15:51:06 EDT 2015 | amrsalama
I have the same problem and while using logicomm it gives an error message (FC107F24) !!! how can I read this error to address the problem ???
