Electronics Forum | Thu Jan 18 09:31:47 EST 2018 | Robl
Hi All, Has anyone had any luck with gang picking the same part on Juki 2060 or FX1R's? Example: 100nf 0402, we can pick this part simultaneously from 8 feeders at once on our Yamaha's (or 12 on the old Sapphires), but on the Juki's we don't seem t
Electronics Forum | Thu Mar 15 18:18:36 EDT 2018 | maustin
Yep, checked the nozzle (that was my first port of call). Had a look at it under our microscope, and also swapped it out for another nozzle to be sure. The problem still exists. You can set the theta speed, but only to Fast, Medium or Slow. I've
Electronics Forum | Sun Mar 18 20:15:06 EDT 2018 | stephenj37824
Thanks so much for the reply. I had looked at Juki but must have missed that model. I see what you are saying about the dispensing. I was looking at the Mycronic solder jet system the My700 I believe. I have watched a few videos detailing the pros an
Electronics Forum | Fri Mar 23 03:18:08 EDT 2018 | bukas
hello Diego, I would start by opening oven and looking for missing components. once you locate them you can work from there. are you using any alu caps on your board? I had problem with bad alu caps exploding in oven and scattering other components.
Electronics Forum | Mon Apr 23 10:22:02 EDT 2018 | robl
It also depends on how good your auditors are. We are very tight on calibration and maintenance across all sites but it's definitely the UK auditors that drive us to be better. They are the ones who match historical builds against tool calibratio
Electronics Forum | Fri May 18 14:40:16 EDT 2018 | raylawre
Currently doing weekly to get a good baseline. Once its satisfied that the oven is stable/repeatable, then it will probably go with a monthly PM. We had an OvenRider in house, so no need to reinvent the wheel and make another vehicle. Keeping it in g
Electronics Forum | Mon May 21 03:54:44 EDT 2018 | robl
Yep, we've had good kit off of Equipmatching.com and this site before, direct from users. Also speak to the manufacturers official distributors as they often look to shift old kit when they are putting in new. Sometimes you have to work hard for
Electronics Forum | Thu Jun 07 13:40:25 EDT 2018 | vetteboy86
Could anyone recommend a lab to send a few assemblies to for evaluation of foreign substance? We had a few assemblies that are conformal coated come back from a customer claiming their is corrosion from water exposure. After evaluation I do not beli
Electronics Forum | Mon Jul 23 10:56:38 EDT 2018 | dleeper
I've never seen this before and I would be suspicious. Have you tried to dust it off with a brush or Q-tip, it might just be some sort of process contamination. Have you looked at the reel to see if the parts are coming in with these spots from the
Electronics Forum | Tue Aug 07 16:59:19 EDT 2018 | solderingpro
Personally I like #1! Being generic isnt always a bad thing. Many times I have come across concepts, products, and ideas that I would not have found had I not been searching through a "greater/broader scope" of topics and subjects. Organization is