Electronics Forum | Thu Jul 08 09:29:10 EDT 2010 | mb_mfg
There are several things that can be done. Shortening the lead length should eliminate bridging between lead. We had done a project several years ago where the customer had shortened the leads to almost flush to the board, preventing any chance of
Electronics Forum | Mon Dec 20 22:41:42 EST 2010 | grantp
Hi, We had it for a while, but had to take it out and replace it with normal convection. I mean the soldering quality is absolutely amazing, and the joints looked perfect, however it was a horror for tomb-stoning. We tried all types of stencil apert
Electronics Forum | Wed Jun 29 14:40:12 EDT 2011 | wrongway
Hello All We are currently running 3 universal smt machines one is an advantis lighting head all 3 machines are 2007 we run 2 shifts 5 days a week I have had very little trouble with them or the feeders. we have 2 universal through hole machines one
Electronics Forum | Mon Aug 29 17:59:24 EDT 2011 | garryc
My first printer was a Speed Print machine back in 2001. We still have it as a backup. I needed a printer quickly so I bought an EKRA from a show. We were very disappointed with that machine. The service was terrible. Parts were impossible to get. I
Electronics Forum | Wed Mar 20 12:59:10 EDT 2013 | kmots15
We had this issue with a few parts on our universal 8mm feeders. The set up was correct all mechanisms were working, even tried a new feeder. The spring in between the take up wheel and pick point just wasnt cutting it since the adheasion was too m
Electronics Forum | Mon May 06 19:21:39 EDT 2013 | amelby
We had that problem on our M12. There were a few > components that had gotten dropped into the > camera area as the hydra head past over it. Our > MY12 has a knob towards the front of the machine > in direct line with the camera. Pulling this
Electronics Forum | Fri Jan 16 16:34:01 EST 2015 | rgduval
It's a four-spindle head. I've already learned the joys of the size of the nozzles...on a job that had an 0603 cap a bit too close to an SOIC. The first panel ran, and the cap placed after the IC...and I had parts everywhere. Got it figured out an
Electronics Forum | Fri Mar 04 10:54:07 EST 2016 | huske
I doubt your machines dirty or calibration is out of wack, unless you beat it up real good. I have had the BX for a few years now and I have personally programmed over 700 recipes. Outside of monthly machine dust wipe downs and re-greasing the y-wag
Electronics Forum | Tue Apr 11 13:01:36 EDT 2017 | mrich208
Yes Sir, someone had replaced the fuse with a resistor and it had burned up. We had an exact board on the VCD. We swapped them and it worked! I am not sure how this forum works but now the machine will zero and say it's missing a part but the sequ
Electronics Forum | Wed Aug 22 11:16:14 EDT 2018 | k_moore
Hello SMTnet goers. I have been tasked with repairing and maintaining the company's feeders. I've done as much as I can with the spares we had in stock but I'm now looking at ordering some spares. We have a few suppliers that we have accounts with