Electronics Forum | Tue Dec 26 10:54:37 EST 2006 | yusufgomec
We use hot air leveling (HAL) process in pcb production. HAL process is 3 steps. �n 1. step flux. 2. step is HAL. And 3. step is rinsing. As you know there is mustn't any flux after rinsing operation. Our flux chemical is water soluable. But there ar
Electronics Forum | Tue Dec 26 20:11:47 EST 2006 | davef
What is the make-up of the residue? Is finding this residue new to your standard operation? What has changed?
Electronics Forum | Tue Jun 21 18:00:26 EDT 2022 | proceng1
I received an email from the OP and I will not be connecting on WHATSAPP.
Electronics Forum | Sat May 24 21:49:24 EDT 2003 | ramanandkini
We have an electronic circuit with a miniature stepper motor, quartz crystal, Electrolytic capacitor,chip resistors and few smt LEDs. The PCB material is CEM1 with SMOBC and HALS finish. This circuit is assembled in a plastic casing and goes in to a
Electronics Forum | Sat Jun 28 22:52:34 EDT 2003 | ramanandkini
We have an Electromechanical assembly (clock) that has a step motor on the board. This electromechanical assembly is assembled in a screw less plastic moulded casing. The plastic casing is neither air tight nor water proof. The board is with SMOBC+ H
Electronics Forum | Fri Jul 04 21:09:04 EDT 2003 | ramanandkini
I have a CEM-1 PCB board with 35 microns copper. This is PCB is finished with SMOBC+HALS. We do solder SMT LEDs, but till date we do not have problems that you have listed. The LEDs are good & bright. It even passed high & low temp cycle tests (-40 t
Electronics Forum | Sun Oct 11 13:53:26 EDT 1998 | Vincenzo Longobardo
I have datas to substain that a not wetting PCB ( the HAL oxided or not uniform in thickness )if soldered in reflow, it shows voids with X-Ray inspection.The voids are in side all the joints not only on the solder pads levell. Is there a technical d
Electronics Forum | Wed Feb 26 04:28:39 EST 2014 | chongns
Hi All member I have a problem on the stable down the color of the white solder mask PCB. first, i tough the color differences was cause by the solder mask ink, but after a close look, the color change are cause by the copper under the solder mask
Electronics Forum | Mon May 14 17:12:20 EDT 2001 | davef
Continuing along the path that Brian took ... IPC-7525 gives design guideline for stepped stencils. It goes something like: * Stepped area SB GT 25 thou from pads located on the greatest thickness of the stencil * Pads in stepped area SB GT 35 tho
Electronics Forum | Thu Sep 23 10:17:26 EDT 1999 | Earl Moon
| | I am attemping to gather as much information on the issues with and progress in solutions for manufacturing Pb free products in response to European initiatives (WEEE). I am intereested in component issues with As Made lead terminations (no Sn/P
