Electronics Forum | Fri Sep 13 13:26:34 EDT 2002 | dougt
If it's not blowing the fuse in the car then I guess it wasn't drawing a huge amount of current. Check the power wires going into the radio and look for something loose. My first guess is your loosing voltage across a bad connection somewhere and a
Electronics Forum | Sun Sep 15 15:08:00 EDT 2002 | jersbo
My 2 cents... Screen printing may very well have a leg up on deciding SMT defects... however if you pay attention to your stencil (aperture size ratio etc..) and inspect your prints... I believe its a much lesser number... (paste MFG also plays a ro
Electronics Forum | Tue Oct 29 15:07:38 EST 2002 | gregp
SOP small outline package, SOIC small outline integrated circuit, VSOP very small outline package, TSOP thin small outline package,TSSOP thin shrink small outline package, QSOP ???, LQFP low profile quad flat pack, VQFP ??? The packages come and go
Electronics Forum | Fri Nov 01 09:46:25 EST 2002 | caldon
Lead Links- Only a small amount of lead can be absorbed through the skin, but nonetheless can be. Any cuts, abrasions raise the risk significantly. Also remember lead can be present on the skin and ingested, again a high degree of concern. From these
Electronics Forum | Wed Nov 20 18:41:57 EST 2002 | slthomas
Here's part of what I could read: "We evaluated the influence of Lift-off (Fillet-lifting) and the influence of thermal fatigue, in this case on combination between various terminal platings of electronic components and Pb-free solder, Sn-37Pb solde
Electronics Forum | Thu Dec 19 11:30:11 EST 2002 | russ
What temp. are you planning on baking them? If this is long term process I would recommend that you hav trays made out of an appropriate ESDS material that can withstand your bake temp (such as duropol)for your QFPs. You can have several patterns/pa
Electronics Forum | Fri Jan 24 21:45:14 EST 2003 | jonfox
We have had to return 6-8 lots out of the last 20 to the board house we (used to) use. From V-score cutting through pads to missing pads (and they say they electrically test our boards?!). I mean, come on, you can look at a PCB and see if there is
Electronics Forum | Mon Feb 24 10:21:29 EST 2003 | ryanm
Just an update on my problem. I spoke to Loctite and they had very few solutions. One thing they suggested to try was to add a thirty-second soak time at 150 degrees to my reflow profile. The problem with that is ramp-soak-spike profiles doesn�t s
Electronics Forum | Mon Feb 24 11:02:42 EST 2003 | Claude_Couture
Every time this problem was brought to me, handling was the problem. Make sure to: 1- track the exact place the components are lost, i.e.: visually inspect the pcb before and after each step in your assembly line. 2- if step one does not pin point t
Electronics Forum | Mon Feb 24 17:56:55 EST 2003 | MA/NY DDave
Hi Let me just give a little and someone else might chip in with fast and ready details. I don't know what your product or service is, so I am not sure how direct to the FDA you need to be for your shop. If you work for someone they should handle t