Electronics Forum | Fri Mar 27 09:37:15 EDT 2009 | cyber_wolf
There are pem nuts on the back side of the teddy bear face. One of them probably fell off and either shorted your main board or it is lodged in the belt and pulley that drives the advancing wheels. Take the front part of the feeder off that has the t
Electronics Forum | Fri Mar 20 10:27:58 EDT 2009 | joelperez
Hello, Has anyone dealt with the process of listing the substances on their electronic products due to REACH? I'm trying to find out if there is a way to globally calculate the area ratio of all the apertures on a solder paste stencil so I can calcu
Electronics Forum | Wed Apr 01 20:21:07 EDT 2009 | tpappano
You are welcome! Talk to Nick at http://www.electronicassemblymachineryexchange.net He is the one who hooked me up with the CSM84VZ, and I think I have seen him post here, too. He has been a very good guy to work with. Tom
Electronics Forum | Wed Apr 01 14:01:33 EDT 2009 | wbrenner
Has anyone used Orbel E-Z SHIELD, Surface mount two-piece fence and cover? They do not recommend pad size, any suggestions In addition, we are considering RFI Clip (Autosplice PN MINI7-V2004115AA/TT). I have concerns about alignment, Possible flo
Electronics Forum | Tue Apr 07 20:06:27 EDT 2009 | davef
We doubt that HASS has much to do with your conformal coat peeling. Sure, poor wicking [low surface energy] could cause the issue that you see. Here are links to a couple of good [no formulas or differential equations] articles on surface energy: * h
Electronics Forum | Wed Apr 08 10:23:38 EDT 2009 | cyber_wolf
I am assuming this machine has a tactile sensor that mounts to the printing table. If the air connection or any of the wire connectors get under the rear rail it will cause the Z to fall. Also any bare wires on the tactile sensor that touch the prin
Electronics Forum | Wed Apr 08 04:29:14 EDT 2009 | kircchoffs
Hi Rodrigo, is your problem occurs only at 2nd device table? how about if you transfer the feeders to the 1st device table? if it happens at both device pls your part data if there's a value at pick-up. you can also check the proper data of the de
Electronics Forum | Tue Apr 14 04:17:47 EDT 2009 | zpivy
PCB Partner has a supplier database with thousands of PCB manufacturers. There is contact information, company introduction, and process capability information of each PCB manufacturer which is publicly collected and then verified by our staff. Suppl
Electronics Forum | Fri Oct 30 07:45:11 EDT 2009 | rwyman
Anyone else wonder why this strain isn't referred to by it's country of origin, as others thruout history have been? e.g. Asian flu, Spanish flu, Hong Kong flu. As far as I'm concerned, this one should be referred to as the Mexican flu. I wonder w
Electronics Forum | Thu Apr 30 12:50:07 EDT 2009 | realchunks
Could be board support. Breakaway boards are a little more flimzy than boards without. A bowed board will cause miss placements - again can be overcome with proper supports (depending on the machine) I would bet that the boards with breakaways h