Electronics Forum | Mon Aug 26 00:17:32 EDT 2013 | alexeis
Hi, After you got datasheets of component shapes (only new one) and enter it to SMT machine library (including Polarity Mark and Position), you can use our software to simulate and fix all angles. Also, our software has tools to add Polarity informa
Electronics Forum | Tue Jul 30 12:30:21 EDT 2013 | JB
We are breaking a 1995 Dek 265GS screen printer for spares, it has the blue under screen cleaner, green 2D inspection camera. Was in full working order before getting a new Dek printer installed. The reason for replacing it was the air line pipes had
Electronics Forum | Tue Aug 20 13:01:48 EDT 2013 | sevenzero
I read through this thread somewhat and checked out the pictures. I've programmed TH lead checks on a newer Yestech and an older Mirtec. I personally use the Yestech white-top/histogram check and the only solder inspection Mirtec has. In my experienc
Electronics Forum | Tue Aug 06 17:43:10 EDT 2013 | davef
I agree with SOB. First, someone is thinking too much and has too much idle time. And second, controlling volatiles from routine fluxing should be much more concerning than volatiles from out-gassing from delamination. In most plants, delamination is
Electronics Forum | Wed Aug 07 16:56:32 EDT 2013 | marcelorotofrance
When I turn the machine on, almost every time I turn the Motor Power Switch it trips. I must to put the lever down and raise it again, then every runs normally. I asked to the former owner about that and told me that this machine always did it so and
Electronics Forum | Mon Aug 19 19:21:42 EDT 2013 | sarason
I would be happy to reverse engineer your file format for the Amistar / Tenryu MT5800VL. I am always up for a reverse engineering file format decode challenge. My website has my program PCBSynergy on it. http://members.iinet.net.au/~sarason/ If you
Electronics Forum | Thu Aug 15 19:31:53 EDT 2013 | dman97
Hello, Does anyone know where I can get programming software for this old machine? It uses some kind of binary file system that I cant seen to figure out. Currently to create a program, I am having to type all individual locations one by one on th
Electronics Forum | Fri Aug 23 00:27:07 EDT 2013 | comatose
I have an AP25 printer, which has served us fine for years. A couple days ago the top quarter of the vision display went all "wiggly" and now it won't find fids. The PC and monitor are fine, so its definitely something in the vision system. Before
Electronics Forum | Tue Sep 03 05:37:06 EDT 2013 | bobpan
It sounds like your dispenser has a problem....The default mod code for 56 is 0 (this should be off). Thats why when you cleared the mod codes the machine was able to home. When you reload your saved mod codes it is probably set to 1. The machine wil
Electronics Forum | Fri Aug 30 22:14:58 EDT 2013 | isd_jwendell
I have used the 850's previous version (and other batch ovens). The current specified was AFTER the unit was at operating temperature, not what it took to warm up. If you have power restrictions, like I do, be careful with this model. Having used ba