Electronics Forum: hasl vs enig (Page 1 of 18)

enig

Electronics Forum | Mon Jan 03 16:34:10 EST 2005 | davef

The main advantage if ENIG over HASL is that ENIG is flat and HASL generally is not. The main disadvanages to ENIG over HASL are: * Cost of ENIG is 1.5 - 2X higher than HASL * Selflife is less than HASL * You solder to nickel, rather than copper * E

enig

Electronics Forum | Tue Jan 04 12:37:41 EST 2005 | Cmiller

We have been using this finish almost exclusively for fine pitch boards for about 5 years. Make SURE you use a board house that does the gold plating in-house. There are some potential issues as DaveF stated. The only problem we have encountered is w

Chosing ENIG vs OSP

Electronics Forum | Mon May 25 07:40:38 EDT 2009 | nibirta

One of our customer wants to change the process from OSP boards to ENIG. His question was: what is the failure rate for ENIG in the last 3 years? well...what to say? I was suggesting a ImAg instead of ENIG. But..nope. Any ideea about this topic? For

Chosing ENIG vs OSP

Electronics Forum | Thu May 28 22:17:18 EDT 2009 | davef

If your fabricator understands and controls their in-house ENIG, you should be OK. It seems that fabs don't undererstand ENIG processes well enough to duplicate hyper-corroded nickel, but those that have not seen the defect usually never see it.

ENIG vs Flash Gold

Electronics Forum | Thu Apr 20 05:57:55 EDT 2006 | Huub

Do you have experience with wear resistance of spring contacts on ENIG vs Flash Au? regards, Huub.

ENIG vs Electroplating

Electronics Forum | Mon May 11 11:05:08 EDT 2009 | milas

Hi 1. Does anyone know what the pros and cons are of ENIG vs Electroplating ? 2. Is there a likelyhood that in either of these processes the gold can flake off after a period of time ? Thanks in advance Milas

Chosing ENIG vs OSP

Electronics Forum | Fri May 29 02:05:34 EDT 2009 | nibirta

So true :) But I think we will have the final fight with the supplier when we will have troubles with the ENIG. We will assembly the product. From my experience, i never found a product with no black pad defects. It depends of the fabrication lots. T

Chosing ENIG vs OSP

Electronics Forum | Tue Jun 02 18:38:13 EDT 2009 | joeherz

Nicoleta, We're a CM and have produced many millions of solder joints with ENIG boards with no failure attributed to this surface finish. This represents several boards houses. Another poster is correct that any supplier you choose should have a c

Chosing ENIG vs OSP

Electronics Forum | Thu Jun 04 01:48:34 EDT 2009 | nibirta

yes, i know this part, and you are right. Tk you once again, Nico

ENIG vs Flash Gold

Electronics Forum | Fri Mar 24 15:44:11 EST 2006 | Hoss

I have no experience with soldering to a flash gold finish. We have specified ENIG for a prototype PCB order and the supplier is asking us if they can use flash gold. They are telling us that the two are interchangable which I don't believe. The

  1 2 3 4 5 6 7 8 9 10 Next

hasl vs enig searches for Companies, Equipment, Machines, Suppliers & Information