Electronics Forum | Wed Mar 09 18:01:53 EST 2005 | dkufta
I know in Florida you must report. I don't know if it is state or federally mandated. I would call to be sure.
Electronics Forum | Wed Mar 09 19:51:28 EST 2005 | KT
Greetings: I would like to know the common land patterns and aperture shapes that are currently in use. We are doing some research on the same. Please respond to the thread if you have a success story with you current design. Thanks KT
Electronics Forum | Fri Mar 11 14:30:03 EST 2005 | ???
i agree with changing the head board if the ribbon cables have been changed. I would also check the quad align card and make sure the cables are plugged in tight to it and to the backplane. There is a large connector on the backplane that sometimes f
Electronics Forum | Tue Mar 15 16:51:59 EST 2005 | Praveen
Hello: I am looking for papers/information on correlation between lead protrusion and reliability studies conducted on Through-Hole Technologies. I would really appreciate it if information on the same could be made available. Thanks and have a nic
Electronics Forum | Wed Mar 16 18:39:55 EST 2005 | KT
I am looking for the same. IPC 610D does mention about the solder fill based on the class (A,B,C). But, there is no exhaustive study that I have come across. Please let me know if you find any. KT
Electronics Forum | Wed Mar 16 15:52:41 EST 2005 | cyber_wolf
Are you using a standard convection reflow oven ? This does not make any sense. I have never heard of anything like this. If you are using a standard oven, then I would say that it is time to get your profiler calibrated.
Electronics Forum | Thu Mar 17 10:34:34 EST 2005 | Rob
Or... If you have an inline glue dispensor, after printing put a glue dot in the centre of the footprint & this should hold it. Rob.
Electronics Forum | Thu Mar 17 09:56:34 EST 2005 | jmedernach
Tx, Your spec limit is the point at which you expect to see a failure. In other words, what is the probability that you'll see a short when you have .008" of solder paste? What is the probability that you'll see an open if you have .004" of solder
Electronics Forum | Thu Mar 17 12:45:54 EST 2005 | Micheal
I am looking for the Procedure to Calibrate the Z-axis gears (blades) on a MPM SPM Screen Printer. Does anyone have it, I would appreciate it.
Electronics Forum | Fri Mar 18 18:51:59 EST 2005 | valuems
Hello Micheal We are looking for the procedure at this time. And there is no tactile sensor on any SPM made by MPM. The SPM's does not have sensor's on the head either. Any way we will send the procedures and the calibration blocks soon. harry
