Electronics Forum | Mon Mar 26 22:42:20 EDT 2007 | sleech
The issue is of drying moisture-sensitive surface-mounted packages is likely to become even more of a baking-headache in light of the upcoming "D" revision to IPC/JEDEC 020. We have taken a simular approach that a major cellular phone firm took in
Electronics Forum | Fri Mar 16 11:21:18 EDT 2007 | cdsullivan
From various research I also found the HT500 series was/is being manufactured by Saint Gobain (part number M797). The product is still available through various distributors, though I imagine the quality issues will still be present. The quality issu
Electronics Forum | Tue Mar 06 14:56:07 EST 2007 | rob_thomas
This is an interesting task you are faced with. If I understand you problem you need to double your throughput ? Is that correct ? If that is the case there are so many more factors to consider besides your equipment, adding more shifts etc. First o
Electronics Forum | Mon Mar 05 16:16:08 EST 2007 | Mark
Hello, We are having issue with one of the customer board. This is 10 layer PCB FR4 with black solder mask. Coating Ni/Au. Soldering leadfree. We are using 7 zones air reflow oven (zones top&bottom). We have bed solder flowing for this boards. T
Electronics Forum | Mon Mar 19 05:51:24 EDT 2007 | pima
Hello I made some test on different oven and problem still occurs. The only progress is that with diffrent thermoprofil ( Ramp to Spike instead of Ramp- Soak- Spike skewed components appears at 1 % of produced parts). With Ramp - Soak-Spike we have p
Electronics Forum | Fri Mar 09 12:41:56 EST 2007 | coop
I have recently been handed over the waving operation here, and am unclear on how to address our recent issue with our Wave. We are using AIM WS-715M Flux in a Foam fluxer, and are using AIM SN-100C in the wave. The problem is on several of the assem
Electronics Forum | Fri Mar 16 23:38:36 EDT 2007 | mika
I don't understand so please explain in more detail. You say ~0.3mm shifted. In what direction is the paste shifted? is it shifted the very same directions on all panels? Only on this product or even with regular pcb:s? What is the size of the panel
Electronics Forum | Fri Mar 16 01:26:31 EDT 2007 | CHITRA K
Many thanks for your reply. We would like to clarify two things; 1. We have recently purchased a vision system with oblique viewing facility to rotate the camera with 40x magnification, which we find useful to inspect fine pitch components . 2. Wh
Electronics Forum | Thu Mar 15 07:04:59 EDT 2007 | chrissieneale
Hello Just wondering if anyone has done trials on how long you can leave paste (tin-lead or pb free) on a board after you have printed it before it starts going 'off'? Thanks Chrissie FYI - have searched and found the 'pasting ahead' thread - jus
Electronics Forum | Thu Apr 05 09:17:40 EDT 2007 | itaig1
I have seen a method used where the pins on the connector are of the same materials as the thermocouple and the connector is connected via single strand wires of the same material to the PCB however the wires were spot welded to bare copper pads to r