Electronics Forum | Wed May 31 20:19:21 EDT 2017 | juliefarrell
Hi Chris, My name is Julie Farrell. I actually work for ICAPE! I am located in Kokomo, IN. I would love to tell you more about our company and how we can help you. That we are a top PCB provider in China. We have 35 manufacturing partners in China.
Electronics Forum | Thu Aug 25 11:53:12 EDT 2016 | shawn_halo_1
Sorry if I was not clear. We have a Flex Circuit Board that is ENIG Finished. There are two connectors that are SMTd to either side of the Flex to connect to other PCBs within the system. Then, we have conductive rubber contacts that are press fit on
Electronics Forum | Thu Aug 25 07:43:24 EDT 2016 | claudea2
We have been having a recurring error on one of our Quad 4Cs. When it picks up the first of 8 47uF SMT capacitor it stops with a limit error. If we do 2 consecutive function 30s, the problem goes away until the next board. The first function 30 re
Electronics Forum | Mon Sep 12 03:38:03 EDT 2016 | rob
Hi John, We picked up a used laser marker (Asys ALS03) last year for around 30K euros and it has done approx 2M codes (we use 6mm square QR) in the last year without fault - it reads them all back to confirm which is handy. We also use labels, and
Electronics Forum | Wed Nov 02 16:35:20 EDT 2016 | csm
Dear FUJI Specialist, I need your HELP, we have an CP8-42-E and machine was working properly and from one day to another when we Turn ON the machine make all the startup and check all the list, when all is ready, you have to Puch Ready and automaticl
Electronics Forum | Thu Dec 08 12:39:39 EST 2016 | deanm
We have a name brand aqueous batch cleaner that uses a chemical and DI water to clean ROL0 flux from our PCBs. It does ok most of the time for SMT boards and we want to include through hole assemblies as well which should be a better cleaning process
Electronics Forum | Wed Dec 14 09:46:48 EST 2016 | westshoredesign
So recently I attempted to do the trackball upgrade for our MPM SPM printer, the touchscreen was unable to calibrate correctly. Unfortunately upon reboot after installing the software the PC wont boot into MS-DOS. It's still functional, as I can brow
Electronics Forum | Wed Dec 14 10:19:56 EST 2016 | jaktechie
Hello, I am new to this forum but I have a question. We use an Orbotech Discovery Ultra to inspect our photo-tools. We currently use this lint free paper as a contrast material underneath the phototool since the vacuum bed on the AOI is black and ou
Electronics Forum | Fri Dec 16 13:37:52 EST 2016 | edhare
Hi all, > > Recently, we are trying to do > wire bonding between a 75 * 75 um pad on a chip > and substrate with 150 um height difference, but > when completing wire bonding and the wire bonds > on pad and substrate, the pad will get out of
Electronics Forum | Thu Dec 29 09:03:03 EST 2016 | sumote
I would cut a piece of cardboard to the same dimensions as your circuit card. Run that through the fluxer of your machine and pull it out before the pre-heater. Take a look at the cardboard and verify that flux has been sprayed on it. That board look