Electronics Forum | Fri Jan 06 12:54:50 EST 2006 | wbaldwin
Does anyone know how (or have a procedure) for calibrating a Pintector machine from Original Solutions? We have one that is in desperate need!
Electronics Forum | Tue Jan 10 17:14:23 EST 2006 | mdemos1
Hi. Thanks for the reply. I will download the test method. This will be a good test from this point forward at the bare board level. I do have a lot of assembled boards that potentially have this problem, however ...
Electronics Forum | Fri Jan 13 11:57:51 EST 2006 | james
I am reworking some BGAs and just trying to find the easiest way to do it. Can you use tacky flux without solder on the pads to reflow? or do you have to have solder on the pads before placing the BGA to reflow? Any info is appreciated. thanks
Electronics Forum | Tue Feb 07 08:33:43 EST 2006 | ppminc
David, Good morning. We have (2) MPM SPMAV printers in stock. If you are interested I can be reached at: sharon@goppm.com Have a good day, Sharon
Electronics Forum | Mon Jan 30 11:57:06 EST 2006 | james
We are running under 5% RH. The parts we are having problems with are QFP 208. We have a clean process and right now I am baking 3 boards before they remove the parts and then sending them back to test.
Electronics Forum | Tue Jan 31 02:59:18 EST 2006 | jgarver1
You also should check to make sure you have blow off at the placing station set properly. I have seen machines with the flow control valve shut completely off not release parts properly. The parts end up in the scrap bin and the machine thinks they
Electronics Forum | Tue Jan 31 20:27:38 EST 2006 | jb
Check http://www.engineeringlab.com I have visited the site before, but never used it, it does have some interesting material though.
Electronics Forum | Sun Jan 29 14:26:24 EST 2006 | gipos
Hi Greg, Try to find someone who is looking for the job and have experince with Comet. There are operators out there which can help you for sure. We have the same problem with Juki 700 series. Hope that you will find someone to help. BR Mike
Electronics Forum | Tue Jan 31 13:20:15 EST 2006 | mgdrouin1
Does anyone have any information regarding damaged caused to components due to overheating primarily with a heatgun? I'm having a hard time getting engineering to comply. Thanks
Electronics Forum | Tue Jan 31 13:22:15 EST 2006 | mgdrouin1
Does anyone have any information regarding damaged caused to components due to overheating primarily with a heatgun? I'm having a hard time getting engineering to comply. Thanks
