Electronics Forum | Thu Feb 21 14:34:29 EST 2013 | danburnikel
I have a product that is ramping up to volumes higher that our batch oven can handle. One option is to apply Loctite E-30CL on to our circuit card and send it through a heller 8 zone oven. Was thinking of a oven temperture of 150C for about 10 minu
Electronics Forum | Tue Feb 26 11:07:21 EST 2013 | capse
hi, First, I'm the Acculogic Rep in the southeastern US. They have an Applications Manager I work with named Vaughan Carlson. Vaughan has run his own test service company. He has worked with my customer on structuring FPT evaluations. His number is 2
Electronics Forum | Mon Mar 04 19:08:17 EST 2013 | marcelorotofrance
Thanks for the contact, I just received the quote, never is too late. I must apologize too, since I consider I have committed excessive vehemence. Also my english is a bit limited, so some of my expressions might seem harsh (I do speak and think in s
Electronics Forum | Thu Mar 07 12:52:02 EST 2013 | rway
We are looking at buying an FX3 AOI. We currently have two M1 systems so I am very familiar with YesTech and their service. I want to know from anyone who currently has one of these FX3 systems if you are satisfied with its operation. Any pros/con
Electronics Forum | Mon Mar 11 09:38:05 EDT 2013 | markhoch
Maybe I misinterpreted, because different people have different names for different devices, (i.e... I believe that the device that you refer to as your "surveyor", I refer to as a "profiler"), but did you already determine that your oven thermocoupl
Electronics Forum | Mon Mar 18 07:32:18 EDT 2013 | stephendo
It's been a long time but one thing I remember from those machines that about 50% of the time the error codes were a wild goose chase. At this point forget what the error code says. Can you move the head? Have you checked the servo cards? Is there
Electronics Forum | Thu Mar 14 17:35:39 EDT 2013 | dontfeedphils
Have you looked at the cover tape wheel on these different feeders and made sure that they are turning correctly when the feeder is advanced? There's not too many things that could be wrong, either the wheel isn't turning properly and keeping the co
Electronics Forum | Thu Mar 14 15:11:33 EDT 2013 | Andy
I am interested in performing SMT Assembly on flex boards that would be a couple of inches wide but 2 to 5 feet long. Obviously quite a challenge. I would like to hear from anyone that may have seen anything similar done, or at least has an idea of h
Electronics Forum | Fri Mar 22 04:20:29 EDT 2013 | jlawson
Also Rehm Thermal Systems Ovens would be worth a look... They are well made, ALL stainless tunnel , 3 phase blowers, highly realiable, and they have new entry level series called VXC Series starting at 6 zones+, but based on same tech and build as t
Electronics Forum | Fri Mar 15 18:44:34 EDT 2013 | anvil1021
We will try both the solder mask and the .001" Kapton and see where we end up with each. This is a fine pitch dual row QFN and we cannot afford too much paste on the .004" stencil we are using. We have experienced shorting in the past with .005" sten