Electronics Forum | Mon Jun 24 14:52:40 EDT 2013 | ryansmta
I am in need of two Fuji or Panasonic "tape and reel" holders. I will be using them to hold dummy 0402 and 0201 outline components which have undergone some special treatment and packaged in tape and reel. This is not for SMT application but for s
Electronics Forum | Mon Jul 01 12:37:38 EDT 2013 | tpost
I do have access to an X-ray but it is only 2-D and it just appears as a black solder joint, not to impressive.. The main question though if it is a reowked solder joint does it still need to show wetting on the lead or can it be covered with solder
Electronics Forum | Mon Jul 01 08:33:55 EDT 2013 | markhoch
A couple things to look at.. Are you using Pb-Free solder? What are the leads of the SD Connector tinned with? Do you have a thermal profiler to use to verify your oven profile? (If not, you may be able to ask a Sales Rep to come in and assist y
Electronics Forum | Mon Jul 01 19:43:44 EDT 2013 | kumar_antom
Hi there, Its a lead free process and the paste that we're using is with this alloy composition : Sn,Ag,Cu,Bi,In.... Pls refer to the attached temp.profile.... This is a mirror Pcb....Same components on both A and B side.... A side doesn't have t
Electronics Forum | Mon Jul 08 14:52:40 EDT 2013 | hegemon
The smaller ball "missing" from the lower left is from solder migrating down into the adjacent via. The solder mask may have been damaged or missing prior to mounting the BGA device. The larger balls at the top right are due to uneven heating during
Electronics Forum | Mon Jul 08 13:19:06 EDT 2013 | williamaxler
There are a lot of things that you need to look at to figure this out. What type of flux are you using? Is this leaded or lead free? Do you have the gradient of the nozzle setup properly? Are these locations tied to plains? With that being said
Electronics Forum | Wed Jul 10 08:50:02 EDT 2013 | mobe1969
Hi SMTnet Members I'm looking for some help with my Westek ICOM500 Ionic tester. It has been sitting for a while. We want to get it up and running. I don't have any tools with this tester. Do you know what material I need to get this to work? Calibra
Electronics Forum | Wed Jul 10 14:14:21 EDT 2013 | benreben
hi all, i have purchased an used vapor phase and i can't make a constant profile. the profiles depend on the time i wait between two batch... the only difference that i include is the chamber temperature i don't understand why the chamber temperat
Electronics Forum | Thu Jul 18 17:51:13 EDT 2013 | justinlevine24
Yes, I have a few in our system. Send me a message with your needed specs and I can match it up for you. Justin Levine OEM Company [Cell] 480-273-6068 email: Justin.l@oemcompany.com www.oemcompany.com
Electronics Forum | Wed Jul 24 12:03:10 EDT 2013 | rway
I agree with JDengler. It is easier to service a machine if there are conveyors between them. You need to also consider how the units get transferred, SMEMA signaling or some other method. Some equipment doesn't support this and an output conveyor